Zenoah PSZ2500 manual Handling Fuel, Transportation

Page 11

5. For safe operation

HANDLING FUEL

1.The engine of the RedMax product is designed to run on a mixed fuel which contains highly flammable gasoline. Never store cans of fuel or refill the tank of the unit in any place where there is a boiler, stove, wood fire, electrical sparks, welding sparks, or any other source of heat or fire which might ignite the fuel.

2.Never smoke while operating the unit or refilling its fuel tank.

3.When refilling the tank, always turn off the engine and allow it to cool down. Take a careful look around to make sure that there are no sparks or open flames anywhere nearby before refueling.

4.Wipe spilled fuel completely using a dry rag if any fuel spillage occurs during refueling.

5.After refueling, screw the fuel cap back tightly onto the fuel tank and then carry the unit to a spot 10 feet (3 m) or more away from where it was refueled before turning on the engine.

TRANSPORTATION

1.Never transport the pruner nor set it down with the engine running. An engine that's running could be accidently accelerated causing the chain to rotate.

2.Make sure the scabbard is in place when transporting the pruner.

3.When carrying by hand, the chain should be pointing backward.

4.Never transport the product over rough roads over long distances by vehicle without removing all fuel from the fuel tank. If doing so, fuel might leak from the tank during transport.

11

Image 11
Contents 848-A52-93A1 PSZ2500Contents Safety FirstPSZ2500 SpecificationsParts location Avertissement Important Engine Information Symbols on the machineWorking Circumstance For safe operationWorking Condition Working Plan Starting the Engine Before Starting the EngineUsing the Product If Someone Comes MaintenanceTransportation Handling FuelBeware of pinching Kickback and Pinching Safety PrecautionsBeware of kickback  13  Set up Hole Moving direction Chain tensioner nut Chain tension adjusting screw Loosen TightenSE4 SE5 SE6 SE7 Pay attention to the correct direction of the saw chainBalance Unit SE8Recommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel and chain oil Chain OIL Fueling the UnitFor Your Engine LIFE, Avoid OP5 Starting Engine OperationOP1 OP2 OP33 OP4Chain oil Adjusting OIL Flow RateOP6 Stopping Engine OP4 Checking OIL SupplyOP9 Adjusting Throttle CableAdjusting Idling Speed OP9 OP7 OP8Guide BAR MaintenanceMaintenance Chart MA1 MA2 MA3 Oiling PortSAW Chain MA4 MA5 MA6Sprocket MA7 MA8 Fuel Filter MA9Gear Case AIR FilterSpark Arrester Replacement Plug is a NGK CMR7ASpark Plug Tightening Torque MufflerCylinder Intake air cooling vent back Procedures to be Performed After Every 100 Hours of USEMA141 MA15 Intake AIR Cooling VentCheck Probable Causes Action Troubleshooting guideStorage Parts list  30   31   32   33  Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC