Zenoah PSZ2500 manual SE4 SE5 SE6 SE7, Pay attention to the correct direction of the saw chain

Page 15

6. Set up

SE4

SE5

SE6

SE7

A standard package contains the items as shown below. (SE4)

(1)Guide bar

(2)Saw chain

(3)Gase case

(4)Sprocket

(5)Chain tension adjust screw

(6)Nut

(7)Chain tensioner nut

(8)Chain cover

Install the guide bar and the saw chain on the gear case as follows.

WARNING

The saw chain has very sharp edges. Use protective gloves for safety.

1.Loosen a nut and remove the chain cover.

2.Mount the guide bar then fit the saw chain around the bar and sprocket.(SE5)

WARNING

Pay attention to the correct direction of the saw chain

3.Fit the chain tensioner nut into the lower hole of the guide bar, then install the chain cover, and fasten the mounting nut to finger tightness. (SE5)(SE6)

(1)Hole

(2)Moving direction

(3)Chain tensioner nut

4.Adjust the chain tension by turning the tensioner screw until the tie straps just touch the bottom side of the bar rail. (SE7)

(1)Chain tension adjusting screw

(a) Loosen

(b) Tighten

15 

Image 15

Contents 848-A52-93A1 PSZ2500Contents Safety FirstSpecifications Parts locationPSZ2500 Avertissement Important Engine Information Symbols on the machineFor safe operation Working ConditionWorking Circumstance Working Plan Starting the Engine Before Starting the EngineUsing the Product If Someone Comes MaintenanceTransportation Handling FuelKickback and Pinching Safety Precautions Beware of kickbackBeware of pinching  13  Set up Hole Moving direction Chain tensioner nut Chain tension adjusting screw Loosen TightenSE4 SE5 SE6 SE7 Pay attention to the correct direction of the saw chainBalance Unit SE8HOW to MIX Fuel Fuel and chain oilRecommended Mixing Ratio Gasoline 50OIL Fueling the Unit For Your Engine LIFE, AvoidChain OIL OP5 Starting Engine OperationOP1 OP2 OP33 OP4Chain oil Adjusting OIL Flow RateOP6 Stopping Engine OP4 Checking OIL SupplyOP9 Adjusting Throttle CableAdjusting Idling Speed OP9 OP7 OP8Guide BAR MaintenanceMaintenance Chart MA1 MA2 MA3 Oiling PortMA4 MA5 MA6 SprocketSAW Chain MA7 MA8 Fuel Filter MA9Gear Case AIR FilterSpark Arrester Replacement Plug is a NGK CMR7ASpark Plug Tightening Torque MufflerCylinder Intake air cooling vent back Procedures to be Performed After Every 100 Hours of USEMA141 MA15 Intake AIR Cooling VentTroubleshooting guide StorageCheck Probable Causes Action Parts list  30   31   32   33  Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC