Zenoah PSZ2500 manual Fueling the Unit, For Your Engine LIFE, Avoid, Chain OIL

Page 18

7. Fuel and chain oil

again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger of early piston seizing due to abnormally lean mixture.

5.Put a clear indication on the outside of the container to avoid mixing up with gasoline or other containers.

6.Indicate the contents on outside of container for easy identification.

FUELING THE UNIT

1.Untwist and remove the fuel cap. Rest the cap on a dustless place.

2.Put fuel into the fuel tank to 80% of the full capacity.

3.Fasten the fuel cap securely and wipe up any fuel spillage around the unit.

WARNING

1.Select bare ground for fueling.

2.Move at least 10feet (3meters) away from the fueling point before starting the engine.

3.Stop the engine before refueling the unit. At that time, be sure to sufficiently agitate the mixed gasoline in the container.

FOR YOUR ENGINE LIFE, AVOID;

1.FUEL WITH NO OIL(RAW GASOLINE) – It will cause severe damage to the internal engine parts very quickly.

2.GASOHOL – It can cause deterioration of rubber and/or plastic parts and disruption of engine lubrication.

3.OIL FOR 4-CYCLE ENGINE USE – It can cause spark plug fouling, exhaust port blocking, or piston ring sticking.

4.Mixed fuels which have been left unused for a period of one month or more may clog the carburetor and result in the engine failing to operate properly.

18

5.In the case of storing the product for a long period of time, clean the fuel tank after rendering it empty. Next, activate the engine and empty the carburetor of the composite fuel.

6.In the case of scrapping the used mixed oil container, scrap it only at an authorized repository site.

NOTE

As lot details of quality assurance, read the description in the section Limited Warranty carefully. Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to the mixed gasoline, etc. described therein, it may not be covered by the warranty.

CHAIN OIL

Use motor oil SAE 10W-30 all year round, or SAE 30-40 in summer and SAE 20 in winter.

NOTE

Do not use waste or regenerated oil that can cause damage to the oil pump.

Image 18
Contents PSZ2500 848-A52-93A1Safety First ContentsSpecifications Parts locationPSZ2500 Avertissement Symbols on the machine Important Engine InformationFor safe operation Working ConditionWorking Circumstance Working Plan Before Starting the Engine Starting the EngineUsing the Product Maintenance If Someone ComesHandling Fuel TransportationKickback and Pinching Safety Precautions Beware of kickbackBeware of pinching  13  Set up Pay attention to the correct direction of the saw chain Chain tension adjusting screw Loosen TightenSE4 SE5 SE6 SE7 Hole Moving direction Chain tensioner nutSE8 Balance UnitHOW to MIX Fuel Fuel and chain oilRecommended Mixing Ratio Gasoline 50OIL Fueling the Unit For Your Engine LIFE, AvoidChain OIL OP33 OP4 OperationOP1 OP2 OP5 Starting EngineChecking OIL Supply Adjusting OIL Flow RateOP6 Stopping Engine OP4 Chain oilOP7 OP8 Adjusting Throttle CableAdjusting Idling Speed OP9 OP9MA1 MA2 MA3 Oiling Port MaintenanceMaintenance Chart Guide BARMA4 MA5 MA6 SprocketSAW Chain MA7 MA8 AIR Filter MA9Gear Case Fuel FilterTightening Torque Muffler Replacement Plug is a NGK CMR7ASpark Plug Spark ArresterIntake AIR Cooling Vent Procedures to be Performed After Every 100 Hours of USEMA141 MA15 Cylinder Intake air cooling vent backTroubleshooting guide StorageCheck Probable Causes Action Parts list  30   31   32   33  Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC