English
8. Operation
OP1
(1)
(2)
(3)
The RedMax stick edgers are designed for edging lawn in gardens, parks, roadsides and so on.
Before starting the engine, take the operating position and adjust the handle position and the wheel height as necessary.
■ADJUSTING WHEEL HEIGHT
1.Loosen the wing nut and change the wheel height to obtain desired cutting depth. (OP1)
(1)Deep cut
(2)Shallow cut
(3)Wing nut
2. After adjusting the height, tighten the wing nut securely.
Tightening Torque:
OP2
OP3 | (1) |
|
(2)
(3)
OP4
(5)
(6)
(4) 
(7)
WARNING
•Never adjust wheel height with the engine running.
■STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine starts.
1.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start rotating upon starting of the engine.
2.Push the primer pump several times until overflown fuel flows out in the clear tube. (OP2)
3.Move the choke lever to the closed position. (OP3)
4.Set the ignition switch to the “Start” position. While pulling the throttle lever, push the throttle set button, and release the throttle, then the throttle lever is in to the “Start position”. (OP4)
5.While holding the unit firmly, pull out the starter rope quickly until engine fires. (OP5)
(1) | Choke lever | (2) | Close |
(3) | Open | (4) | Ignition switch |
(5) | Start | (6) | Stop |
(7) | Throttle set button |
| |
IMPORTANT
•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.
26