Zenoah G3000 manual Sawing, SA1 SA2, To Avoid Kickback SA1, Felling a Tree SA2

Page 13

8. Sawing

SA1

SA2

NOTE

Before proceeding to your job, read “For Safe Operation” section. It is recommended to first practice sawing easy logs. This also helps you get accustomed to your unit.

It is not necessary to force the saw into the cut. Apply only light pressure while running the engine at full throttle.

Racing the engine with the chain seized in a cutaway can damage the clutch system. When the saw chain is caught in the cut, do not attempt to pull it out by force, but use a wedge or a lever to open the cut.

TO AVOID KICKBACK (SA1)

Hold the chain saw firmly with both hands.

Do not overrach.

Do not let the nose of the guide bar contact a log, branch, ground or any other obstruction.

Cut at high engine speeds.

Don’t cut above shoulder height.

Follow manufacturer’s sharpening and maintenance instructions for the saw chain.

FELLING A TREE (SA2)

WARNING

When you fell a tree, be sure to warn your neighboring workers of the danger.

1.Decide the felling direction considering the wind, Iean of the tree, location of heavy branches, ease of job after felling, and other factors .

2.While clearing the area around the tree, arrange a good foothold and retreat path.

3.Make a notch cut one-third of the way into the tree on the felling side.

4.Make a felling cut from the opposite side of the notch and at a level slightly higher than the bottom of the notch.

13

Image 13
Contents 2631-93111205 G3000Page Contents Safety FirstParts location SpecificationsG3000 Symbols on the machine For safe operation Kickback Safety Precautions for Chain SAW Users SE1 SE2 SE3 SE4 SE5 Installing guide bar and saw chainFuel and chain oil 25 1 Mix ChartFuel Recommended mixing ratioOP1 OP2 OP3 OP4 OP5 Fueling the Unit OP1 OperationStarting Engine Checking OIL Supply OP6 OP7 OP8Stopping Engine Needle 11⁄4±1⁄4 OP9 Adjusting Carburetor OP9SA1 SA2 SawingTo Avoid Kickback SA1 Felling a Tree SA2Cutting an unpillowed log SA3 SA4 SA5 Logging and LimbingCutting a pillowed log SA6 Daily Maintenance SAW Chain MaintenanceMA1 MA2 MA3 MA4 AIR Filter MA5 MA6 MA7 MA8 Guide BARMA9 Monthly Maintenance Fuel FilterOiling Port GeneralHandle Mounting Joints Storage