Zenoah G3000 MA9, Oiling Port, General, Monthly Maintenance Fuel Filter, OIL Strainer, Spark Plug

Page 18

9. Maintenance

MA9

MA10

MA11

MA12

.025 in

0.6 mm

MA13

OILING PORT

Dismount the guide bar and check the oiling port for blocking by sawdust. (MA9)

GENERAL

Inspect the entire unit for fuel leakage, Ioose fastenings, and damage to major parts, especially handle joints and guide bar mounting. When anything wrong be found, make sure to have it repaired before next usage.

MONTHLY MAINTENANCE

FUEL FILTER

When the engine runs short of fuel supply, check the fuel filter for blockage. (MA10)

OIL STRAINER

Drain the oil tank and remove the oil strainer located near the spark plug. Check the condition and clean if necessary. (MA11)

SPARK PLUG

Starting failure and mis-firing are often caused by a fouled spark plug. Periodically clean the spark plug and check that the spark gap is in the correct range. (MA12)

For a replacement plug, use Champion CJ-8Y or RCJ-8Y, or NGK BPM7A.

DRIVE SPROCKET

Periodically check the drive sprocket for wear and damage, and replace when the teeth have worn over 1mm, or when any damage has been observed. (MA13)

18

Image 18
Contents G3000 2631-93111205Page Safety First ContentsSpecifications Parts locationG3000 Symbols on the machine For safe operation Kickback Safety Precautions for Chain SAW Users Installing guide bar and saw chain SE1 SE2 SE3 SE4 SE5Fuel 25 1 Mix ChartFuel and chain oil Recommended mixing ratioOperation OP1 OP2 OP3 OP4 OP5 Fueling the Unit OP1Starting Engine OP6 OP7 OP8 Checking OIL SupplyStopping Engine OP9 Adjusting Carburetor OP9 Needle 11⁄4±1⁄4To Avoid Kickback SA1 SawingSA1 SA2 Felling a Tree SA2SA3 SA4 SA5 Logging and Limbing Cutting an unpillowed logCutting a pillowed log SA6 Maintenance Daily Maintenance SAW ChainMA1 MA2 MA3 MA4 MA5 MA6 MA7 MA8 Guide BAR AIR FilterOiling Port Monthly Maintenance Fuel FilterMA9 GeneralStorage Handle Mounting Joints