Zenoah G3000 manual Storage, Handle Mounting Joints

Page 19

9. Maintenance

HANDLE MOUNTING JOINTS

Inspect the handle mounting joints and replace when any adhered part is peeled off or a crack is observed on the rubber part. Also replace when the inside of the rear damper metal has worn remarkably.

10. Storage

1.Empty the fuel tank and run the engine out of fuel.

2.Empty the oil tank.

3.Clean the entire unit.

4.Store the unit in a dry place out of the reach of children.

19

Image 19
Contents 2631-93111205 G3000Page Contents Safety FirstParts location SpecificationsG3000 Symbols on the machine For safe operation Kickback Safety Precautions for Chain SAW Users SE1 SE2 SE3 SE4 SE5 Installing guide bar and saw chainRecommended mixing ratio 25 1 Mix ChartFuel and chain oil FuelOP1 OP2 OP3 OP4 OP5 Fueling the Unit OP1 OperationStarting Engine Checking OIL Supply OP6 OP7 OP8Stopping Engine Needle 11⁄4±1⁄4 OP9 Adjusting Carburetor OP9Felling a Tree SA2 SawingSA1 SA2 To Avoid Kickback SA1Cutting an unpillowed log SA3 SA4 SA5 Logging and LimbingCutting a pillowed log SA6 Daily Maintenance SAW Chain MaintenanceMA1 MA2 MA3 MA4 AIR Filter MA5 MA6 MA7 MA8 Guide BARGeneral Monthly Maintenance Fuel FilterMA9 Oiling PortHandle Mounting Joints Storage