Zenoah G3000 manual MA5 MA6 MA7 MA8 Guide BAR, AIR Filter

Page 17

9. Maintenance

MA5

MA6

MA7

MA8

GUIDE BAR

1.Remove sawdust in the bar groove and the oiling port. (MA5)

2.Grease the nose sprocket from the feeding port on the tip of the guide bar. (MA6)

3.Periodically turn over the guide bar when mounting it to the unit, in order to prevent partial wear.

4.The bar rail should always be a square. Check for wear of the bar rail. Apply a ruler to the bar and the outside of a cutter. If a gap is observed between them, the rail is normal. Otherwise, the bar rail is worn. Such a bar needs to be corrected or replaced. (MA7)

AIR FILTER

A clogged air filter can reduce the engine performance. Daily check the filter elements and tap off attached saw dust. When cleaning, use warm, soapy water and dry completely before installing. When the element is broken or shrunk, replace with a new one. (MA8)

17

Image 17
Contents 2631-93111205 G3000Page Contents Safety FirstG3000 SpecificationsParts location Symbols on the machine For safe operation Kickback Safety Precautions for Chain SAW Users SE1 SE2 SE3 SE4 SE5 Installing guide bar and saw chainFuel and chain oil 25 1 Mix ChartFuel Recommended mixing ratioStarting Engine OperationOP1 OP2 OP3 OP4 OP5 Fueling the Unit OP1 Stopping Engine OP6 OP7 OP8Checking OIL Supply Needle 11⁄4±1⁄4 OP9 Adjusting Carburetor OP9SA1 SA2 SawingTo Avoid Kickback SA1 Felling a Tree SA2Cutting a pillowed log SA3 SA4 SA5 Logging and LimbingCutting an unpillowed log SA6 MA1 MA2 MA3 MA4 MaintenanceDaily Maintenance SAW Chain AIR Filter MA5 MA6 MA7 MA8 Guide BARMA9 Monthly Maintenance Fuel FilterOiling Port GeneralHandle Mounting Joints Storage