WARNING: Always stop engine, discon- nect spark plug, and ground against engine before cleaning, lubricating or performing any maintenance on your machine.
Engine
Refer to the separate engine manual for engine mainte- nance instructions.
•Maintain engine oil as instructed in the separate engine manual packed with your unit. Read and follow instructions carefully.
•Service air cleaner every ten hours under normal conditions. Clean every hour under extremely dusty conditions. Poor engine performance and flooding usually indicates that the air cleaner should be serviced. To service the air cleaner, refer to the separate engine manual packed with your unit.
IMPORTANT: Never run your engine without air cleaner completely assembled.
•The spark plug should be cleaned and the gap reset every 25 hours of engine operation. Spark plug replacement is recommended at the start of each tiller season; check engine manual for correct plug type and gap specification.
•Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to permit proper air circulation which is essential to engine performance and life. Be certain to remove all dirt and combustible debris from muffler area.
Lubrication
Transmission
The transmission is
Tine Shafts
Remove tine assemblies and lubricate the tine shafts at least once a season.
Wheel Shaft
Remove wheel assembly and lubricate the axle shaft at least once a season.
Cleaning Tine Area
Clean the underside of the tine shield after each use. The dirt washes off the tines easier if rinsed off im- mediately instead of after it dries. Always towel dry the tiller afterwards and apply a light coat of oil or silicone to prevent rusting or water damage.
IMPORTANT: Never use a “pressure washer” to clean your tiller. Water can penetrate tight areas of the tiller causing serious damage.
Replacing the Belt
Your tiller has been engineered with a belt made of special material for longer life and better performance. It should not be replaced with an
1.Remove the frame and engine by removing the six screws and lock nuts holding the engine and frame to the shield, Figure
Figure 6-1: Remove engine and frame to gain access to the belt.
2.Loosen the lock nut shown in Step A Figure 6-2.
3.Unloop the belt from the pulleys, Step B Figure
4.Reassemble the new belt and tighten the lock nut.
5.Reattach frame and engine using the hardware removed earlier.
A
B
Figure 6-2: Loosen the nut to remove the belt.
6
Maintaining
Your Tiller
WARNING
Always stop engine, disconnect spark plug, and ground against engine before cleaning, lubricat- ing or performing maintenance on your machine.
IMPORTANT: Never use a pressure washer to clean your tiller. Water can penetrate tight areas of the tiller causing serious damage to the unit.
IMPORTANT: Never run your engine without the air cleaner completely assembled.
11