Bolens 241 warranty Making Adjustments, Engine Adjustment, Tine Width Adjustment

Page 10

5

Making Adjustments

Adjustments

NOTE: This operator’s manual may cover vari- ous models of tillers.

The units illustrated may vary slightly from your unit. Follow only those instructions which pertain to your model number.

NOTE: Stand behind the tiller as if you were going to operate it. Your right hand cor- responds to the right side of the tiller; your left hand corresponds to the left side of the tiller.

Warning: Disconnect the spark plug wire and ground it against the engine before performing any adjustments.

Engine Adjustment

Refer to the separate engine manual for engine adjustment instructions.

Tine Width Adjustment

The tilling width of the unit is 22 inches. Tilling width can increase to 24 inches by removing the clevis and cotter pins, sliding each outer tine out one inch, and securing in this position with the pins. For cultivation, reduce the tine width to 13 inches by removing the outer tines completely, Figure 5-1.

24-inch

22-inch

13-inch

Figure 5-1: Tine width adjustment.

10

Image 10

Contents Front Tine Tiller Model 772C0814 11/28/2005Finding and Recording Model Number Table of ContentsCustomer Support Preparation TrainingOperation Maintenance & Storage This manual On the machineAssembly AssemblySqueeze the tine clutch control inward. Insert right Rear Wheel with Depth Stake Know Your TillerTine Clutch Control Handle KnobsStarting Engine Using Your TillerBefore Starting Stopping EngineCultivating Controlling Speed and Tilling DepthHandle Pressure Transporting and Storing the Tiller Depth stake to the highest position, FigureEngine Adjustment Making AdjustmentsTine Width Adjustment Engine Cleaning Tine AreaMaintaining Your Tiller LubricationOff-Season Storage Off-Season StorageTrouble Shooting Problem Cause RemedyPage Parts List Pièces Détachées Part Description RÉF PièceWarranty TWO Year Limited WarrantyFor parts and/or accessories refer to customer support on Page Com.mtdproducts SituationAvenue non Ne dents Les Solution Cause ProblèmeDépannage Surchauffe moteur LeSaison Hors Remisage Très est IlCourroie La de ReplacementEntretien Dents des NettoyageRéglages Utilisation Motoculteur du remisage et TransportProfondeur de guide du Réglage Travail de profondeur la de et vitesse la de ControleMoteur le Arrêter MotoculteurMoteur du Démarrage Motoculteur du Commandes Assemblage Réglages Et Montage’huile à et carburant au quant moteur du Remisage et Entretien Responsabilité VotrePréparation FonctionnementGénéral en Utilisation Matières des Table Vente-après ServiceModèle de numéro le trouver Pour ’utilisation Entretien La voir détachées Pièces’UTILISATION Notice 241 Modèle l’avant à dents à Motoculteurs