Bolens 241 warranty This manual On the machine, Maintenance & Storage

Page 4

2

Safe

Operation

Practices

WARNING

This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before at- tempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol.

HEED ITS WARNING!

Your Responsibility Restrict the use

of this power machine to persons who read, understand

and follow the warnings and instructions

in this manual

and on the machine.

17.If the machine should start making an unusual noise or vibration, stop the engine, disconnect the spark plug wire and ground it against the engine. Inspect thoroughly for damage. Repair any damage before starting and operating.

18.Keep all shields, guards and safety devices in place and operating properly.

19.Never pick up or carry machine while the engine is running.

20.Use only attachments and accessories approved by the manufacturer. Failure to do so, can result in personal injury.

21.If situations occur which are not covered in this manual, use care and good judgment. Contact Customer Support or your authorized dealer.

Maintenance & Storage

1.Never tamper with safety devices. Check their proper operation regularly.

2.Check bolts and screws for proper tightness at frequent intervals to keep the machine in safe working condition. Also, visually inspect machine for any damage.

3.Before cleaning, repairing, or inspecting, stop the engine and make certain the tines and all moving parts have

stopped. Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.

4.Do not change the engine governor settings or over-speed the engine. The governor controls the maximum safe operat- ing speed of the engine.

5.Maintain or replace safety and instruction labels, as neces- sary.

6.Follow this manual for safe loading, unloading, transporting, and storage of this machine.

7.Never store the machine or fuel container inside where there is an open flame, spark or pilot light such as a water heater, furnace, clothes dryer etc.

8.Always refer to the operator’s manual for proper instructions on off-season storage.

9.If the fuel tank has to be drained, do this outdoors.

10.Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.

4

Image 4
Contents Front Tine Tiller Model 772C0814 11/28/2005Finding and Recording Model Number Table of ContentsCustomer Support Preparation TrainingOperation Maintenance & Storage This manual On the machineAssembly AssemblySqueeze the tine clutch control inward. Insert right Know Your Tiller Tine Clutch ControlRear Wheel with Depth Stake Handle KnobsUsing Your Tiller Before StartingStarting Engine Stopping EngineCultivating Controlling Speed and Tilling DepthHandle Pressure Transporting and Storing the Tiller Depth stake to the highest position, FigureEngine Adjustment Making AdjustmentsTine Width Adjustment Cleaning Tine Area Maintaining Your TillerEngine LubricationOff-Season Storage Off-Season StorageTrouble Shooting Problem Cause RemedyPage Parts List Pièces Détachées Part Description RÉF PièceWarranty TWO Year Limited WarrantyFor parts and/or accessories refer to customer support on Page Com.mtdproducts SituationAvenue non Solution Cause Problème DépannageNe dents Les Surchauffe moteur LeSaison Hors Remisage Très est IlLa de Replacement EntretienCourroie Dents des NettoyageRéglages Utilisation Motoculteur du remisage et TransportProfondeur de guide du Réglage Travail de profondeur la de et vitesse la de ControleMoteur le Arrêter MotoculteurMoteur du Démarrage Motoculteur du Commandes Assemblage Réglages Et Montage’huile à et carburant au quant moteur du Remisage et Entretien Responsabilité VotrePréparation FonctionnementGénéral en Utilisation Vente-après Service Modèle de numéro le trouver PourMatières des Table ’utilisation Entretien La voir détachées Pièces’UTILISATION Notice 241 Modèle l’avant à dents à Motoculteurs