Bolens 241 warranty Assembly, Squeeze the tine clutch control inward. Insert right

Assembly	3
1. Remove the star handle knobs and carriage bolts from
the lower handle, Figure 3-1.

Assembly

Figure 3-3: Install left side of the tine clutch control.

Figure 3-1: Remove hardware from lower handle.

2.Position the upper handle onto the lower handle, Step A Figure 3-2. Align the holes on lower handle with the holes on the upper handle (choose the upper or lower holes depending on the desired handle height).

3. Insert carriage bolts through the holes and secure with star knobs, Step B Figure 3-2. Make certain carriage bolts are seated securely into one of the two positions provided.

A

Figure 3-4: Hook cable into tine clutch control.

B

B

Figure 3-2: Attach and secure upper handle.

4. Insert left end of tine clutch control into the hole on the left side of the upper handle, Figure 3-3.

5.Insert the Z-fitting on the clutch cable into the hole on the tine clutch control. Hook the “Z” end into the opening from the inside to the outside as shown in

Figure 3-4.

6. Squeeze the tine clutch control inward. Insert right

end into the hole on the right side of the upper handle, Figure 3-5: Install right end of tine clutch control. Figure 3-5.

NOTE: Stand behind the tiller as if you were going to operate it. Your right hand corresponds to the right side of the tiller; your left hand corresponds to the left side of the tiller.

NOTE: This operator’s manual may cover various models of tillers. The units illustrated may vary slightly from your unit. Follow only those instructions which pertain to your model number.

IMPORTANT This unit is shipped without gasoline or oil in the engine. Fill up gasoline and oil as instructed in the accom- panying engine manual BEFORE operating your machine.

5