Honda Power Equipment Honda Mini-Tiller, FG110 specifications Air Filter Check, Air Filter Cleaning

Page 15

 

 

SERVICING YOUR TILLER

Air Filter Check

 

1.

Move the choke lever [1] to the CLOSED () position to

[3]

 

prevent dirt from entering the engine.

[2]

 

 

2.

Squeeze together the air cleaner upper tab [3] at the top of

[1]

 

the air cleaner cover [5] to release it from its catch, then flip

 

the cover down to remove it.

3. Remove the air filter [6] and check it to be sure it is clean and in good condition.

4. If the air filter is dirty, clean it as described under Air Filter Cleaning. Replace the air filter if it is damaged.

NOTICE

 

Operating the engine without an air filter, or with a damaged

 

air filter, will allow dirt to enter the engine, causing rapid

 

engine wear. This type of damage is not covered by the

[6]

Distributor’s Limited Warranty.

 

5. Align the air filter [6] with the air cleaner base [2] as shown.

[5]

[4]

Reinstall the air filter by locating the three air cleaner base

pegs into the three air filter holes [7]. Slide the air filter over the pegs until it is flush with the air cleaner base.

NOTICE

An improperly installed air filter will allow dirt to enter the engine, causing rapid engine wear. Make sure the air filter is properly installed and flush with the air cleaner base before installing the air cleaner cover.

6.Reinstall the air cleaner cover [5] by hooking the two lower tabs [4] on the bottom of the cover and snapping the upper tab [3] into place.

Air Filter Cleaning

A dirty air filter restricts air flow to the carburetor, reducing engine performance. If you operate the engine in very dusty areas, clean the air filter after each refueling.

1.Remove the air filter.

2.Clean the air filter in warm soapy water [1]. Rinse and allow it to dry thoroughly [2]. Or, clean in nonflammable solvent and allow it to dry.

3.Dip the air filter in clean engine oil [3], then squeeze out all excess oil [4]. The engine will be hard to start or will smoke when started if too much oil is left in the air filter.

NOTICE

Operating the engine with a dry air filter will allow dust to enter, causing engine damage.The air filter must be oiled after cleaning.

4.Wipe dirt from the air cleaner base and cover using a moist rag. Be careful to prevent dirt from entering the carburetor.

5.Reinstall the air filter and air filter cover.

[7]

[6]

[1]

[2]

[3]

[4]

ENGLISH

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Contents FEW Words about SafetyEnglish IntroductionImportant Message to Employers Tiller SafetyImportant Safety Information Attachments and ModificationsTiller Safety Safety Label LocationsProduct Identification Plate Component & Control Locations Controls & EquipmentDescription of Controls Controls & EquipmentDrag Bar Transport WheelsCarrying Handle Recoil Starter GripIs Your Tiller Ready to GO? Before OperationAre YOU Ready to Operate the TILLER? Is Your Working Area READY?Safe Operating Precautions Drag Bar InstallationMoving the Tiller Starting The Engine OperationTine Installation Tiller OperationOperating Tips Servicing Your Tiller Importance of MaintenanceMaintenance Safety Safety PrecautionsServicing Your Tiller Maintenance ScheduleEngine Oil Recommendations EngineEngine Oil Level Check Engine Oil ChangeAir Filter Check Air Filter CleaningAn incorrect spark plug can cause engine damage Spark Plug ServiceCarburetor Adjustment Cooling Fin InspectionThrottle Cable Inspection Fuel System RefuelingFuel Recommendations Fuel Tube Inspection Fuel Filter and Fuel Tank CleaningTransmission Lubrication Importance of Proper Assembly Important Safety PrecautionsSET-UP Before Operation SET-UPUnpacking Adding OILStorage Preparation STORAGE-TRANSPORTINGTransporting Storage PrecautionsSTORAGE-TRANSPORTING Removal from StorageTaking Care of Unexpected Problems LOW Power or Engine Speed WON’T IncreaseEngine will not Start Technical & Consumer Information Serial Number LocationsCarburetor Modifications for High Altitude Operation Specifications Technical & Consumer InformationEmissions Control System Information Faaa TuneupHonda Publications Customer Service InformationConsumer Information Find an Authorized Honda Servicing Dealer in Your AreaMini-Tiller FG110

Honda Mini-Tiller, FG110 specifications

The Honda Power Equipment FG110 Mini-Tiller is a compact and versatile gardening tool designed to simplify soil preparation for gardeners and landscapers alike. With its robust engineering, user-friendly features, and advanced technologies, the FG110 stands out as an essential machine for both home users and professionals.

One of the main features of the FG110 is its lightweight design, weighing in at just 29 pounds. This makes it easy to maneuver around the garden, even in tight spaces. The mini-tiller boasts a powerful Honda 4-stroke engine that provides reliable performance without the need for mixing oil and gas. The fuel-efficient engine ensures longer run times, allowing users to tackle larger areas without having to frequently refuel.

The FG110 is equipped with a set of durable tines that are designed to penetrate tough soil effortlessly. With a working width of 9 inches and a tilling depth of up to 8 inches, it effectively turns soil, aerating the ground and promoting healthier plant growth. The adjustable tilling width allows for greater flexibility, letting users customize their tilling experience based on specific gardening needs.

This mini-tiller features a low-vibration design that ensures comfort during extended use. The ergonomically designed handle can be easily adjusted to accommodate users of various heights, offering better control and reducing fatigue. Moreover, the FG110 is equipped with a convenient transport wheel, making it easier to move from one location to another without straining the body.

Another noteworthy aspect of the Honda FG110 is its reliability and maintenance-friendly design. The air-cooled, 4-stroke engine is easy to maintain, and the overall construction of the tiller is built to withstand challenging conditions. The quick-start system allows users to start the engine with minimal effort, getting them to work faster.

In summary, the Honda FG110 Mini-Tiller combines power, efficiency, and ease of use into a compact package ideal for any gardening enthusiast. Its lightweight design, powerful engine, versatile tines, and user-friendly features make it an excellent choice for both residential and professional gardening tasks, ensuring that soil preparation is no longer a daunting chore but a straightforward and enjoyable experience. With Honda's reputation for quality and durability, the FG110 is a reliable companion for a thriving garden.
Top Page Image Contents