Viper 5500 manual Directed Electronics-all rights reserved

Page 20

Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death. (1) Never remotely start the vehicle with the vehi- cle in gear, and (2) Never remotely start the vehicle with the keys in the ignition. The user must also have the neutral safety feature of the vehicle periodically checked, wherein the vehicle must not remotely start while the car is in gear. This testing should be performed by an authorized Directed Electronics dealer in accordance with the Safety Check out- lined in the product installation guide. If the vehicle starts in gear, cease remote start operation immediately and con- sult with the authorized Directed Electronics dealer to fix the problem.

After the remote start module has been installed, contact your authorized dealer to have him or her test the remote start module by performing the Safety Check outlined in the product installation guide. If the vehicle starts when per- forming the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The remote start module must be removed or the installer must properly rein- stall the remote start system so that the vehicle does not start in gear. All installations must be performed by an authorized Directed Electronics dealer. OPERATION OF THE

REMOTE START MODULE IF THE VEHICLE STARTS IN GEAR IS CONTRARY TO ITS INTENDED MODE OF OPERATION. OPER- ATING THE REMOTE START SYSTEM UNDER THESE CONDI- TIONS MAY RESULT IN PROPERTY DAMAGE OR PERSONAL

© 2006 Directed Electronics—all rights reserved

17

Image 20
Contents Model 5500 Owners Guide Limited Lifetime Consumer Warranty Directed Electronics-all rights reservedDirected Electronics-all rights reserved Table of Contents Disabling the Remote Start System What is Included Important InformationIVU, In vehicle receiver unit HHU, hand held unitDirected Electronics-all rights reserved Remote Control Diagram Standard Remote Configuration System Maintenance Standard Button Configurations Arm icon will flash when the system is locking the doors Vibrate icon will be displayed when the Vibrate Mode is on Remote Operation and Programming System Signal Paging Features Programmable Remote Control Features Using Your System Directed Electronics-all rights reserved Directed Electronics-all rights reserved Locking Unlocking Disabling the Starter Kill Without a Transmitter To enter or exit Valet Mode Panic ModeTo remote start the vehicle When you are ready to drive the vehicle To perform Valet Take-Over Short-Run/Turbo Starter Anti-Grind Circuitry Location of Shutdown Switch Rapid Resume LogicProgramming Options Glossary of Terms Convenience Expansions Directed Electronics-all rights reserved Directed Electronics-all rights reserved Quick Reference Guide Company behind this system is Directed Electronics