Viper 5500 manual When you are ready to drive the vehicle

When you are ready to drive the vehicle:

1. Insert the ignition key and

turn it to the ON (not the

START) position.

2. Press the brake pedal.

NOTE: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.

While the vehicle is running during remote start operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shut-down inputs:

■The brake pedal is pressed.

■The hood is opened.

■The shutdown toggle switch is put into the OFF position.

■The pre-programmed run time (12, 24, or 60 minutes) has elapsed.

■Transmitter button is pressed again twice to start the vehicle.

Rear Defogger

To turn the rear defogger output OFF:

1.Simultaneously press & release the + + but- tons on the remote control.

2.The lights will flash 2 times.

3.The rear defogger output will no longer activate when the vehicle is remote started.

© 2006 Directed Electronics—all rights reserved 23