✂
QUICK REFERENCE GUIDE:
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet.
✂
To lock/arm using your remote
■To arm the system press 
for one second. The doors will lock (if con-
nected). The LED will begin to flash. The Failsafe® Starter Kill will pre- vent the vehicle’s starter from cranking if it has been installed. The ve- hicle’s horn (if connected) will honk and the parking lights will flash once to confirm arming of the system.
To unlock/disarm using your remote
■To disarm the system press 
for one second. The doors will unlock (if
connected). The Failsafe® Starter Kill will be deactivated and the vehicle’s horn (if connected) will honk twice and the parking lights will flash twice.
Disabling the Failsafe® Starter Kill without a transmitter
■Turn on the ignition. Press and release the Valet switch within 10 sec- onds. The LED will stop flashing and the vehicle should start. Be sure to check with the installer for the location of the Valet switch.
To remote start the vehicle
■Press 
. The parking lights will turn on (if connected) and the vehi- cle will start and run for the programmed amount of time.
To enter or exit Valet Mode
■Turn the ignition to the "ON" position. Turn the ignition back off. Press and release the Valet switch within 10 seconds. The status LED will light steadily if you have entered Valet Mode. To exit Valet Mode, repeat the steps above. The LED will turn off when exiting Valet Mode.
To activate Panic Mode
■Press and hold 
for 1.5 seconds.
To disable the remote start system
■To disable the remote start, move the shutdown toggle switch to the OFF position.
Location of Shutdown Switch______________________________
Rear Window Defogger
■Press the 
, 
and 
buttons simultaneously to turn the defog- ger on or off when remote starting. When a remote start is initiated, the
parking lights will flash
© 2006 Directed | 33 |