Viper 5500 manual To remote start the vehicle

Page 25

Remote Start

This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehi- cle with the climate control system. If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must be set to the desired level prior to remote starting the vehicle.

IMPORTANT! (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the key in the ignition.

To remote start the vehicle:

1.Press on the transmitter 2 times.

2.The parking lights will flash to confirm that the vehicle will attempt to start.

3.Release the buttons as soon as the parking lights flash. (In gasoline vehicles, the engine will start 4 seconds after

the parking lights flash. In diesel vehicles, the engine will start when the WAIT-TO-START indicator on the vehicle's dash goes out.)

4.Once the vehicle has started, it will run for the pre-program- med period of time (either 12, 24, or 60 minutes - see Programming Options section of this guide) or until a shut- down input is triggered.

22

© 2006 Directed Electronics—all rights reserved

Image 25
Contents Model 5500 Owners Guide Directed Electronics-all rights reserved Limited Lifetime Consumer WarrantyDirected Electronics-all rights reserved Table of Contents Disabling the Remote Start System Important Information What is IncludedHHU, hand held unit IVU, In vehicle receiver unitDirected Electronics-all rights reserved Remote Control Diagram Standard Remote Configuration System Maintenance Standard Button Configurations Arm icon will flash when the system is locking the doors Vibrate icon will be displayed when the Vibrate Mode is on Remote Operation and Programming System Signal Paging Features Programmable Remote Control Features Using Your System Directed Electronics-all rights reserved Directed Electronics-all rights reserved Locking Unlocking Disabling the Starter Kill Without a Transmitter Panic Mode To enter or exit Valet ModeTo remote start the vehicle When you are ready to drive the vehicle To perform Valet Take-Over Short-Run/Turbo Starter Anti-Grind Circuitry Rapid Resume Logic Location of Shutdown SwitchProgramming Options Glossary of Terms Convenience Expansions Directed Electronics-all rights reserved Directed Electronics-all rights reserved Quick Reference Guide Company behind this system is Directed Electronics