Seat Latch and Adjustment
WARNING
•Do not operate the vehicle with the ROPS removed. Doing so could result in property damage, personal injury, or death.
•Do not remove or modify any component of the ROPS structure. Doing so will result in voiding the ROPS certification and could weaken the ROPS, resulting in serious injury or death.
•Do not operate the vehicle if the ROPS is damaged. If the ROPS is damaged, replace the structure. Do not attempt repair.
•The driver and passenger must be restrained at all times with the seat belts provided to help prevent injury in the event of sudden braking, collision, or
•In the event of a
•After inserting the tab, make sure the tab and buckle are locked and that the belt is not twisted.
•Loose fitting seat belts could increase the chance of injury due to sliding under the belt if sudden braking should occur. Keep the safety belt snug and positioned as low on the hip bone as possible.
•Use a single safety belt for one person at a time. Do not use a single safety belt for two or more people – this includes children.
•No more than one person per bucket seat at one time. No more than two persons per bench seat at one time. Do not allow people to ride in any part of the vehicle that is not equipped with a seat and a safety belt. Do not allow a passenger to hold a child in his or her lap while the vehicle is moving.
•This vehicle is not designed to meet child seat compatibility requirements. Children requiring a child safety seat must not ride on the vehicle. Comply with state and local laws pertaining to child safety.
CAUTION
•Be careful not to damage the safety belt webbing or hardware.
•Inspect the safety belt system periodically. Check for cuts, fraying, and loose parts. Damaged parts should be replaced immediately. Do not disassemble or modify the system.
•Keep seat belts clean and dry. If cleaning is necessary, use a mild soap and lukewarm water solution. Do not use bleach, dye or abrasive cleaners as they may severely weaken the seat belts.
•Do not insert coins, clip, etc. in the buckle as this may prevent the tab from locking into the buckle properly.
•If the safety belt does not function normally, contact your dealer/distributor or trained technician immediately. Do not occupy the seat until the safety belt is repaired.
SEAT LATCH AND ADJUSTMENT
The vehicle seat(s) are hinged to allow easy access to the engine compartment. To raise the seat bottom, grasp the rear side of the seat bottom, and pull firmly in a forward/upward direction. See following WARNING.
WARNING
•Make sure seat hinges and latches are securely engaged before operating the vehicle. Vehicles with bucket seat option:
The
HUV 4421 Owner’s Manual | Page 21 |