Generac 004189-1 Emission Control System Warranty, Emission Related Parts Include the Following

Page 59

Section 10 – Warranty

Guardian Liquid-cooled 15 kW, 20 kW and 25 kW Generators

EMISSION CONTROL SYSTEM WARRANTY

Emission Control System Warranty (ECS Warranty) for 1995 and later model year engines:

(a)Applicability: This warranty shall apply to 1995 and later model year engines. The ECS Warranty Period shall begin on the date the new engine or equipment is purchased by/delivered to its original, end-use purchaser/owner and shall con- tinue for 24 consecutive months thereafter.

(b)General Emissions Warranty Coverage: Generac warrants to the original, end-use purchaser/owner of the new engine or equipment and to each subsequent purchaser/owner that each of its engines is ...

(1)Designed, built and equipped so as to conform with all applicable regulations adopted by the CARB pursuant to its authority, and

(2)Free from defects in materials and workmanship which, at any time during the ECS Warranty Period, may cause a war- ranted emissions-related part to fail to be identical in all material respects to the part as described in the engine man- ufacturer’s application for certification.

(c)The ECS Warranty only pertains to emissions-related parts on your engine, as follows:

(1)Any warranted, emissions-related parts that are not scheduled for replacement as required maintenance in the Owner’s Manual shall be warranted for the ECS Warranty Period. If any such part fails during the ECS Warranty Period, it shall be repaired or replaced by Generac according to Subsection (4) below. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(2)Any warranted, emissions-related part that is scheduled only for regular inspection as specified in the Owner’s Manual shall be warranted for the ECS Warranty Period. A statement in such written instructions to the effect of “repair or replace as necessary” shall not reduce the ECS Warranty Period. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(3)Any warranted, emissions-related part that is scheduled for replacement as required maintenance in the Owner’s Manual shall be warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part shall be repaired or replaced by Generac according to Subsection

(4)below. Any such emissions-related part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period prior to the first scheduled replacement point for such emissions-related part.

(4)Repair or replacement of any warranted, emissions-related part under this ECS Warranty shall be performed at no charge to the owner at a Generac Authorized Warranty Service Facility.

(5)When the engine is inspected by a Generac Authorized Warranty Service Facility, the owner shall not be held responsi- ble for diagnostic costs if the repair is deemed warrantable.

(6)Generac shall be liable for damages to other original engine components or approved modifications proximately caused by a failure under warranty of any emission-related part covered by the ECS Warranty.

(7)Throughout the ECS Warranty Period, Generac shall maintain a supply of warranted emission-related parts sufficient to meet the expected demand for such emission-related parts.

(8)Any Generac authorized and approved emission-related replacement part may be used in the performance of any ECS Warranty maintenance or repairs and will be provided without charge to the owner. Such use shall not reduce Generac ECS Warranty obligations.

(9)Unapproved, add-on, modified, counterfeit and/or “grey market” parts may not be used to modify or repair a Generac engine. Such use voids this ECS Warranty and shall be sufficient grounds for disallowing an ECS Warranty claim. Generac shall not be held liable hereunder for failures of any warranted parts of a Generac engine caused by the use of such an unapproved, add-on, modified, counterfeit and/or “grey market” part.

EMISSION RELATED PARTS INCLUDE THE FOLLOWING:

1) Fuel Metering System:

3)

Ignition System including:

1.2) LPG/Natural Gas carburetion assembly and its internal

 

a) Spark plug

components.

 

b) Ignition module

a) Fuel controller (if so equipped)

4)

Catalytic Muffler Assembly (if so equipped) including:

b) Mixer and its gaskets (if so equipped)

 

a) Muffler gasket

c) Carburetor and its gaskets (if so equipped)

 

b) Exhaust manifold

d) Primary gas regulator (if so equipped)

5)

Crankcase Breather Assembly including:

 

e) LP liquid vaporizer (if so equipped)

a) Breather connection tube

2) Air Induction System including:

 

a) Intake pipe/manifold

 

b) Air cleaner

 

*Generac engine types covered by this warranty statement include the following:

1)Prepackaged Standby Generator

2)Auxiliary Power Unit (APU) Generator

3)Standby Generator

Part 2

Generac® Power Systems, Inc. 57

Page 58 Page 60
Image 59
Page 58 Page 60
Contents Power SYSTEMS, INC Introduction Authorized Service Dealer LocationOperation and Maintenance HOW to Obtain ServiceIntroduction IFC Safety Rules General Hazards Electrical Hazards Generator AC Connection Systems Transfer SwitchGenerator Automatic System OperationEngine Protective Devices High Coolant Temperature SwitchLOW OIL Pressure Switch LOW Coolant Level SwitchLifting the Generator SpecificationsUnpacking Engine OIL Recommendations Torque SpecificationsBefore Installation Fuel ConsumptionNfpa Standards Standby Generator InstallationGenerator Location Other Published StandardsEmergency Circuit Isolation Method Basic Standby Electric SystemTotal Circuit Isolation Method Grounding the GeneratorVented Batteries Transfer Switch Start Signal ConnectionsBattery Installation Prior to Initial START-UP Using a Standard GTS Transfer SwitchPreparation Before START-UP Control Console Components Automatic Operation Meter Reading Selector SwitchSET Exercise Time Switch Manual Transfer and Start UP Retransfer and ShutdownChecking Fluid Levels Engine HeaterCooling System Overload Protection for Engine DC Electrical SystemMaintenance OWNER/OPERATOR can Perform Coolant Change Changing the Engine AIR CleanerBattery Replacement Miscellaneous MaintenanceCleaning the Generator BatteryTroubleshooting Points Service Maintenance Interval Information Level Maintenance Level Electrical Data Electrical Data Electrical Data AC Outlet Outlet AC Circuit FED DOOR, Enclosure Ground Wire AssemblyBRACE, Side BumperGenerac Power Systems, Inc Hinge Slip Male RH Washer NylonHinge Slip Male LH Hinge Slip Female LHGenerac Power Systems, Inc SWITCH, Toggle Dpdt CMA BOX AssemblyRocker Switch Dpst SWITCH, Selector AMP/VOLTGenerac Power Systems, Inc Switch Dpst 5 125V SPD Rckr Switch 6A AMP/V SelectorHarness Wiring 1.5L DECAL, TRANS. Switch ConnGenerac Power Systems, Inc Radiator 1.5L Tank Coolant RecoveryBracket Coolant Recovery Tank Support RadiatorGenerac Power Systems, Inc NUT HEX M6 -1.0 G8 YEL CHR Venturi 1.5LGuard FAN Hose RES 5/8 RIA 250FFlat WASHER-M8 BASE, MountingISOLATOR-VIBRATION ISOLATOR, VibrationWasher Shakeproof EXT 5/16 STL Dampener VibrationWasher Flat M8 Earth StrapNipple TOE 2 NPT X 4.5 BLK Iron Muffler W/RAIN ShldMufflr Strap 6IN DIA Elbow 90 DEG 2 NPTFlex Pipe Exhaust Manifold Exhaust 1.5LNipple TOE 1.5 NPT X 6.5 BL Iron Pipe ExhaustCircuit Breaker 70 X 2 240V 39782 Brkt Silkscreen P PanelCover BQ Circuit Breaker Bracket Mounting Circuit BreakerPP Logic ASM 50/60HZ Harness CMA WireAssy Home Stdby Logic DECAL, CMA LabelBattery Post Cover RED+ ASSY,WIRE#16 REDBolt Battery Hold Down BAR Battery HolddownAssembly Carburator Linkage Housing Governor ConnectorConnector Interface Assembly Cover Connector HousingGenerac Power Systems, Inc Assy Rotor 20KW Housing BlowerAssy Rotor 10KW Assy Rotor 15KWGenerac Power Systems, Inc Solenoid GAS Fuel Cover AIR CleanerWeldment Mounting Base Flange Fuel InletGenerac Power Systems, Inc ENGINE-1.5L Switch OIL PressureARM Adjust Alternator Ground Wire StarterInstallation Air Outlet Air Intake Installation Air Intake PURCHASER’S/OWNER’S Warranty Responsibilities Your Warranty Rights and ObligationsMANUFACTURER’S Emission Control System Warranty Coverage Emission Related Parts Include the Following Emission Control System WarrantyThis Warranty Shall not Apply to the Following Warranty Schedule

004371-2, 004188-1, 004474-1, 004475-1, 004370-2 specifications

Generac Power Systems is renowned for its commitment to providing reliable power solutions, and their various models, including the Generac 004189-1, 004370-2, 004475-1, 004474-1, and 004188-1, showcase the company’s innovative engineering and technology. Each of these models is designed to meet diverse energy needs, ensuring homeowners and businesses can maintain power during outages or in remote locations.

The Generac 004189-1 is an essential model in the lineup known for its robust construction and user-friendly interface. It features a powerful engine, ensuring reliable power output and efficient fuel consumption. Additionally, its lightweight design makes it portable, allowing easy relocation to different sites. The model integrates advanced technology for automatic voltage regulation, safeguarding sensitive electronics while operating.

Moving on to the Generac 004370-2, this model emphasizes advanced start-up technology. It is equipped with a reliable electric start feature, minimizing the effort required to power up the generator. Its noise-dampening design significantly reduces sound levels, making it ideal for residential use without causing disturbances to neighbors. The unit also includes a durable metal enclosure that helps protect the generator from the elements and increases its lifespan.

The Generac 004475-1 model stands out for its enhanced fuel efficiency and low emissions. This eco-friendly design adheres to strict emissions regulations, making it a suitable choice for environmentally conscious users. Its intuitive control panel provides easy monitoring of power output, fuel levels, and maintenance needs, ensuring users can efficiently manage their energy requirements.

Similarly, the Generac 004474-1 exemplifies convenience and performance with its dual fuel capability, allowing it to operate on both gasoline and propane. This flexibility ensures users can easily switch fuels based on availability and cost-effectiveness. The model also boasts an extended runtime, capable of powering essential appliances and systems for prolonged periods during outages.

Finally, the Generac 004188-1 emphasizes ease of use, featuring a comprehensive user manual and a straightforward assembly process. The model provides ample power capacity, making it excellent for both emergency back-up and recreational activities. Its compact design allows storage in confined spaces, while its efficient cooling system prevents overheating during extended use.

Overall, these Generac models reflect the company's dedication to innovation, quality, and user satisfaction. With features aimed at enhancing convenience, performance, and environmental responsibility, they cater to the varying power demands of modern users.
Top Page Image Contents