Black Box LE171, LE172, LE075A-R2, LE073AE-R2 Connecting an AUI Cable to the Media Unit, 3 LE075A

Page 10

CHAPTER 3: Installation

NOTE

Both ends of the T- connector must be attached to network cabling. If the Adapter is at the end of a network segment, the end of the T-connector not attached to the network must have a 50-ohm terminator installed.

3.2.3 LE075A

For the Modular Parallel Adapter for AUI, refer to Fig. 3-4.

After connecting the connector, press the slide latch to the left to lock the connector into place.

NOTE

For use with an external power supply only. Not to be used with the SPC!

Fig. 3-4. Connecting an AUI Cable to the Media Unit.

9

Image 10

Contents Modular Parallel Adapters Modular Media Units FCC Statement Contents Specifications BNC IntroductionAvailable Models AUIFeatures Illustrates a typical adapter and media unitInstallation Attach the Media UnitConnect the Network Cable 1 LE071A and LE073AConnecting an RG-58/U Coaxial Cable to the Media Unit 2 LE072A and LE074AConnecting an AUI Cable to the Media Unit 3 LE075AInstall the Self-Powering Cable SPC Plug the Ethernet Adapter into the ComputerInstall the AC Power Adapter Installing the AC Power AdapterSupplied Files Software Setup and OperationDOS ODI Driver for Novell NetWare \ETHERNET\POCKET\EPP Frame ETHERNET802.2 Disablelink Link Driver Setodi Polling UnidirMicrosoft LAN Manager EnabledLSL Setodi Ipxodi Netx EPP Disablelink Modadpt Adapter DRIVERNAME=SETNDIS$ Polling UnidirMicrosoft Windows for Workgroups LANtastic/Al version 5.x Driver DRIVERNAME=SETNDIS$Share Packet DriverHELP, XEROX, IEEE, MPX ServerModular Parallel Adapters and Modular Media Units Self-Test and Diagnostics DiagnosticsLPT Report Adapter failed to initialize correctly Error MessagesModadpt Ethernet Adapter is not connected or not powered Modadpt Ethernet Adapter Memory RAM failureCustomer Service Information Copyright 1996. Black Box Corporation. All rights reserved