Briggs & Stratton Generac Generator Discount Parts Call
SPECIFICATIONS
ENGINE TECHNICAL
INFORMATION
This is a single cylinder, overhead valve(OHV), air cooled engine. It is a low emissions engine.
In the State of California, this type of engine is certified by the California Air Resources Board to meet emissions standards for 1000 hours. Such certification does not grant the purchaser, owner or operator of this engine any additional warranties with respect to the performance or operational life of this engine.The engine is warranted solely according to the product and emissions warranties stated elsewhere in this manual.
PRODUCT
SPECIFICATIONS
Generator Specifications
Starting Wattage | 13,500 Watts |
Wattage | 8,000 Watts |
Rated AC Load Current: |
|
At 120 Volts | . .66.6 Amps |
At 240 Volts | . .33.3 Amps |
Phase | |
Rated Frequency | . . .60 Hertz |
Shipping Weight | . . . . .240 lbs. |
Emissions Compliance Period
This engine is certified to meet the United States Environmental Protection Agency (USEPA) Phase 2 emission standards. For phase 2 certified engines, the Emissions Compliance Period referred to on the Emissions Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. For engines less than 225 cc displacement, Category C = 125 hours, B = 250 hours and A = 500 hours. For engines of 225 cc or more, Category C = 250 hours, B = 500 hours and A = 1000 hours.
This engine has an Air Index of 3.The EPA Emissions compliance period is Category A.The displacement of this engine is 407 cc.
Engine Specifications
Rated Horsepower . . . . . . . . . . . . . . . . . . . 15 at 3600 rpm Bore . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90 mm Stroke . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64 mm Displacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 407 cc Spark Plug
Type: . . . . . . . . . . . . Champion RC14YC or Equivalent
Set Gap To: . . . . . . . . . . . . . . . . . . 0.030 inch (0.76 mm)
Valve clearance with valve springs installed and piston is at top dead center (check when engine is cold).
Intake . . . . . . . . . . . . . . . . .
Above 40° F . . . . . . . . . . . . . . . . . . .SAE 30 or
15
www.mymowerparts.com