Briggs & Stratton 030211 Install Wheel KIT, Refer to and install the wheel kit as follows

6200W Portable Generator

INSTALL WHEEL KIT

The wheel kit is designed to greatly improve the portability of your generator.

NOTE: Wheel kit is not intended for over-the-road use.

You will need a 1/2" or 13mm socket wrench, a 1/2" or 13mm open end wrench, a 7/16" socket wrench, 7/16" open end wrench and a needle-nose pliers to install this kit.

NOTE: Adjustable wrenches may be substituted for open end wrenches.

Refer to Figure 2 and install the wheel kit as follows:

1.Place the bottom of the generator frame on a flat, even surface.Temporarily place unit on blocks to ease assembly.

2.Slide axle through both axle mounting brackets on cradle frame, as shown in Figure 2.

3.Slide a wheel over the axle.

NOTE: Be sure to install both wheels with the air pressure valve on the outboard side.

4.Slide a flat washer over the axle and place the e-ring onto the groove in the axle.

5.Place one end of the needle nose pliers on the bottom of the axle and the other end of the pliers on top of the e-ring. Seat the e-ring by pressing the pliers closed.

6.Repeat step 3 through 5 to secure second wheel.

7.Remove the temporary blocks.

8.Attach the vibration mounts to the support leg with 1/4-20 x 3/4” capscrews and 1/4-20 lock nuts.

9.To aid support leg assembly, rest generator on cradle, engine end down. Remove the existing locknut from the left unit vibration mount with 13mm wrench. Use the same locknut to attach the support leg.

10.Attach the other side of the support leg with a M6 x 20 mm cap screw and M6 lock nut. Rest generator on wheels and support leg.

11.Check each fastener to ensure it is secure and the tires are inflated between 15-40 PSI.

Figure 2 — Install Wheel Kit

	Wheel
Use existing hardware	Flat Washer
to attach left side of
support leg to unit	Axle
Hex Nut
Support Leg	Cap Screw
	E-Ring
Vibration Mount
Cap Screw	Hex Nut
	7