Agilent Technologies E8257D/67D manual Checking the Output Power

Operation Verification

Checking the Output Power

Perform the following procedure to check the signal generator output power:

1. Zero and calibrate the power sensor to the power meter as shown:

2. Connect the equipment as shown:

3.Press Preset.

4.Press RF On/Off. The RF On annunciator is now displayed.

5.Press Mod On/Off. The Mod Off annunciator is now displayed.

6.Press Frequency and enter the first frequency value listed in Table 3-1.

7.Press Amplitude and enter the amplitude value for your option and frequency value.

8.Measure the power level.

9.Repeat step 6 through 8 and measure the power levels for each remaining frequency listed in Table 3-4thru Table 3-6. Record any power levels not within the acceptable limits.