Poulan PP265E27, 428550, 96198002800 owner manual Troubleshooting

Page 20

TROUBLESHOOTING

See appropriate section in manual unless directed to an authorized service center/department.

PROBLEM

 

CAUSE

 

CORRECTION

Does not start

1.

Fuel shut-off valve (if so

1.

Turn fuel shut-off valve to OPEN position.

 

 

equipped) in OFF position.

 

 

 

2.

Safety ignition key

2.

Insert safety ignition key.

 

 

is not inserted.

 

 

 

3.

Out of fuel.

3.

Fill fuel tank with fresh, clean gasoline.

 

4.

Throttle in STOP position

4.

Move throttle to FAST position

 

5.

Choke in OFF position.

5.

Move to FULL position.

 

6.

Primer not depressed.

6.

Prime as instructed in the Operation section of this manual.

 

7.

Engine is flooded.

7.

Wait a few minutes before restarting, DO NOT prime.

 

8.

Spark plug wire is

8.

Connect wire to spark plug.

 

 

disconnected.

 

 

 

9.

Bad spark plug.

9.

Replace spark plug.

 

10.

Stale fuel.

10.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

11.

Water in fuel.

11.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

 

 

 

 

Loss of power

1.

Spark plug wire loose.

1.

Reconnect spark plug wire.

 

2.

Throwing too much snow.

2.

Reduce speed and width of swath.

 

3.

Fuel tank cap is covered

3.

Remove ice and snow on and around fuel tank cap.

 

 

with ice or snow.

 

 

 

4.

Dirty or clogged muffler.

4.

Clean or replace muffler.

 

 

 

 

 

Engine idles or

1.

Choke is in FULL position.

1.

Move choke to OFF position.

runs roughly

2.

Blockage in fuel line.

2.

Clean fuel line.

 

3.

Stale fuel.

3.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

4.

Water in fuel.

4.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

5.

Carburetor is in need of

5.

Contact an authorized service center/department.

 

 

adjustment or overhaul.

 

 

 

 

 

 

 

Excessive

1.

Loose parts or damaged

1.

Tighten all fasteners. Replace damaged parts. If vibration

vibration

 

augers or impeller.

 

remains, contact an authorized service center/department.

 

 

 

 

 

Recoil starter

1.

Frozen recoil starter.

1.

See “IF RECOIL STARTER HAS FROZEN”

is hard to pull

 

 

 

in the Operation section of this manual.

 

 

 

 

 

Loss of traction

1.

Drive belt is worn.

1.

Check / replace drive belt.

drive / slowing

2.

Drive belt is off of pulley.

2.

Check / reinstall drive belt.

of drive speed

3.

Friction drive wheel is worn.

3.

Contact an authorized service center/department.

 

 

 

 

 

Loss of snow

1.

Auger belt is off of pulley.

1.

Check / reinstall auger belt.

discharge or

2.

Auger belt is worn.

2.

Check / replace auger belt.

slowing of

3.

Clogged discharge chute.

3.

Clean snow chute.

snow discharge

4.

Augers / impeller jammed.

4.

Remove debris or foreign object from augers / impeller.

 

 

 

 

 

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model Number Snow ThrowerSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents Assembly / PRE-OPERATION HOW to SET UP Your Snow ThrowerParts Packed Separately in Carton Remove Snow Thrower from CartonUnfold Upper Handle Install Speed Control ROD See FigsInstall Traction Drive Control ROD See Figs Install Auger Control ROD See Figs Install Discharge Chute / Chute Rotator Head See FigInstall Chute Deflector Remote Control See Figs Check Tire PressureOperation Know Your Snow ThrowerPrimer Ignition KEYMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting engineHOW to USE Your Snow Thrower StoppingTo Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigTo Throw Snow See Fig Before Starting the Engine To Start EngineIf Recoil Starter has Frozen Snow Throwing TipsBefore Stopping Maintenance Cleaning EngineService and Adjustments To Adjust Snow Thrower HeightChute Deflector Shear Bolts See FigTo Replace Belts See Fig To Adjust Cable Tension See Fig To Remove Wheels See FigCarburetor Engine SpeedStorage OtherFuel System Engine OILTroubleshooting Auger Housing KEY Part DescriptionScraper BAR Auger 27 LH23 22 KEY Part NO. NO. Description Auger Bearing Bearing PlugDeflector Control Assembly Deflector Spring 15 420679 Service Part Deflector ControlChute Weldment Deflector WeldmentLEVER/CABLE Rotator Assembly Cable Assembly AdjustableCable Assembly Heat Shield Rotator HeadLoop Handle LH Loop Handle RHLower Tube Pivot SupportSpacer RetainerKnob RED Handle KnobImpeller ROD Assembly Traction ROD AssemblyShifter ROD TOP Shifter ROD BottomWire Harness Console PanelHeadlight Bezel Flood HeadlightAxle Shaft Roll PIN 3/16Sprocket Clik PINExploded Assembly Drive Plate AssemblySpeed Selector Rubber RingCover Assembly Frame427963X428 Engine Mounting PlateImpeller Belt Traction BeltIdler ARM Bracket Idler Pulley187865X421 Wheel Assembly LH187833X421 Power Cord Retainer PINWrench Remote Spring181037 DECAL, DangerDECAL, DANGER, Deflector DECAL, InstructionKEY Part Description QTY Warranty MANUFACTURER’S Warranty CoverageII. Emission Control System Warranty Warranty Limited Warranty

PP265E27, 96198002800, 428550 specifications

The Poulan 428550, also known as the PP265E27, is a robust and versatile trimmer designed for both residential and professional use. This model stands out due to its exceptional combination of power, lightweight design, and user-friendly features, making it an excellent choice for anyone looking to maintain their lawn and garden effectively.

One of the main features of the Poulan 428550 is its reliable 25cc 2-cycle engine. This powerful engine provides a significant amount of torque, enabling users to cut through thick grass, weeds, and even light brush with ease. The engine’s design prioritizes efficiency and durability, ensuring that it can handle a variety of trimming tasks without compromising performance.

The lightweight construction of the PP265E27 is another significant advantage. Weighing in at approximately 10 pounds, this trimmer is easy to maneuver, reducing user fatigue during extended periods of use. The adjustable handle allows for ergonomic positioning, making it comfortable for users of different heights and helping to reduce strain on the back and arms.

One of the standout technologies in the Poulan 428550 is its Smart Start feature. This innovative technology is designed to make starting the engine as easy as possible. It reduces the resistance in the starting cord by 30%, allowing even novice users to start the trimmer with minimal effort. This feature is especially valuable for those who may struggle with traditional pull-start engines.

Another characteristic of the PP265E27 is its dual-line cutting system. This system includes a 17-inch cutting width, which allows for efficient trimming of larger areas in less time. The trimmer uses a bump feed mechanism, enabling users to quickly advance the line as needed without stopping work. This ensures that users can maintain their momentum while tackling their yard maintenance tasks.

Durability is an essential factor in the design of the Poulan 428550. Its sturdy construction and high-quality materials ensure that it can withstand the rigors of regular use. Additionally, its low-vibration design helps to minimize fatigue, making it suitable for extended use without discomfort.

In summary, the Poulan 428550, or PP265E27, is a highly efficient and user-friendly trimmer that combines power, lightweight construction, and innovative features. Whether for residential or occasional professional use, this model provides reliability and effectiveness, making it a valuable addition to any lawn care toolkit. Its combination of a powerful engine, ergonomic design, and advanced technology ensures that users can tackle their trimming tasks with ease and efficiency.
Top Page Image Contents