MTD OGST-3106 manual Troubleshooting, OFF-SEASON Storage

Page 18

SECTION 8: OFF-SEASON STORAGE

WARNING: Never store engine with fuel in tank indoors or in poorly ventilated areas, where fuel fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or other gas appliance.

•If unit is to be stored over 30 days, prepare engine for storage as instructed in the engine manual.

•Remove all debris from the exterior of equipment.

•Follow lubrication recommendations on page 13.

•Always store the snow thrower in a clean, dry area.

NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rust proof the equipment. Using a light oil or silicone, coat the equipment, especially any chains, springs, bearings and cables.

SECTION 9: TROUBLESHOOTING

Problem

 

Cause

 

Remedy

 

 

 

 

 

Engine fails to start.

1.

Fuel tank empty, or stale fuel.

1.

Fill tank with fresh gasoline.

 

2.

Blocked fuel line.

2.

Clean the fuel line.

 

3.

Choke not in ON position

3.

Move switch to ON position

 

4.

Faulty spark plug.

4.

Clean, adjust gap or replace.

 

5.

Safety key not in ignition switch on engine.

5.

Insert the key fully into the switch.

 

6.

Spark plug wire disconnected.

6.

Connect spark plug wire.

 

7.

Primer button not being used properly.

7.

Refer to the engine manual.

Engine runs erratic.

1.

Unit running on CHOKE.

1.

Move choke lever to OFF position.

 

2.

Blocked fuel line or stale fuel.

2.

Clean fuel line and fill tank with clean, fresh

 

 

 

 

gasoline.

 

3.

Water or dirt in fuel system.

3.

Drain fuel tank and carburetor. Refill with

 

 

 

 

fresh fuel.

 

4.

Carburetor out of adjustment.

4.

Refer to the engine manual.

Loss of power.

1.

Spark plug wire loose.

1.

Connect and tighten spark plug wire.

 

2.

Gas cap vent hole plugged.

2.

Remove ice and snow from gas cap. Be

 

 

 

 

certain vent hole is clear.

 

3.

Exhaust port plugged.

3.

Refer to the engine manual.

Engine overheats.

1.

Carburetor not adjusted properly.

1.

Refer to the engine manual or have the

 

 

 

 

carburetor adjusted by an authorized

 

 

 

 

engine service dealer.

Excessive vibration.

1.

Loose parts or damaged auger.

1.

Stop engine immediately and disconnect

 

 

 

 

spark plug wire. Tighten all bolts and nuts. If

 

 

 

 

vibration continues, have unit serviced by

 

 

 

 

an authorized service dealer.

Unit fails

1.

Traction control cable in need of adjustment.

1.

Adjust traction control cable. Refer to

to propel itself.

 

 

 

Adjustments.

 

2.

Drive belt loose or damaged.

2.

Replace drive belt.

Unit fails

1.

Discharge chute clogged.

1.

Stop engine immediately and disconnect

to discharge snow.

 

 

 

spark plug wire. Clean discharge chute and

 

 

 

 

inside of auger housing.

 

2.

Foreign object lodged in auger.

2.

Stop engine immediately and disconnect

 

 

 

 

spark plug wire. Remove object from auger.

 

3.

Auger control cable in need of adjustment.

3.

Refer to Final Adjustments in Assembly

 

 

 

 

Section.

 

4.

Auger belt loose or damaged.

4.

Refer to Adjustments.

 

5.

Shear bolt(s) sheared.

5.

Replace shear bolt(s).

NOTE: For repairs beyond minor adjustments listed above, contact the local dealer.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Operator’s Manual Table of Contents Important Safe Operation Practices TrainingMaintenance And Storage Your ResponsibilityAssembling Your Snow Thrower Items Required For AssemblyBefore Assembly Assembling Handle Loose PartsAttaching the Chute Assembly Attaching Chute CrankWheel Drive Control & Shift Lever Chute Clean-Out ToolFinal Adjustments Auger ControlKnowing Your Snow Thrower Tire Pressure Pneumatic TiresDrive Control / Auger Control Lock Shift Lever Safety Ignition KeyChute Clean-Out Tool Discharge ChuteGas & Oil Fill-Up Operating Your Snow ThrowerBefore Starting To Start EngineTo Engage Wheel Drive To Engage AugersOperating Tips Auger Control Chute AssemblyShift Rod Wheel Drive ControlGeneral Recommendations Maintaining Your Snow ThrowerSkid Shoe LubricationEngine Friction Wheel RubberDrive Belts Wheel Drive Control / Auger Control LockShave Plate and Skid Shoes Servicing Your Snow ThrowerAugers Replacing Belts Auger BeltDrive Belt Changing Friction Wheel Rubber Sprocket Hex ShaftTroubleshooting OFF-SEASON StorageThree 3 Year Limited Warranty Tractor Attachment Warranty103 Part RÉF Pièce Description Serrez à un couple de 20-30 po-lb Part RÉF Pièce Description RÉF Pièce Description 20 19 3468 58A 58B Part RÉF Pièce Description 995 x 12,0 Lg po Couple de 325-550 po-lb Style Style Commerciale Utilisation Dépannage DE Guide 9 Chapitre UregFi Nongpi du Hex Moyeu Arbre NongPiGoulotte Frottement de roueCaoutchouc en bague la de Changement La de manivelle la et courroie-couvre le RemontezCourroies les de Remplacement Moteur Patins et LameTarières ’entraînement CourroiesGénéral d’ordre Recommandations LubrificationTarière la de Commande Patin’éjection Goulotte Roues des l’entraînement de Commande La de commande la de réglage tout pour réglages»Goulotte la de et patins des tarière ’utilisation Conseils Tarières les de EmbrayageLaissez Remarque ’huile et d’essence Pleins Démarrage le AvantTrous trois à courant de prise une avez vous Si Vitesses de Levier ’autre de Que plus côté d’un tirer de risque machine la pneus, lesTous dans égale pas n’est pression la Si Remarque Goulotte la de dégagement de Outil Le dans roues» des l’entraînement de «CommandeRéglages Derniers La à «Réglages» chapitreGoulotte la de manivelle la de Montage Goulotte la de MontageExcessivement Montage 2 Chapitre Cisaillement de BoulonsSouffleuse la de châssis le de l’arrière à Regardez Responsabilité Votre Remisage ET Entretien Préparation FormationEgl’assembla Procéder de Avant EgPa Contenu’utilisation Notice

OGST-3106 specifications

The MTD OGST-3106 is an innovative and versatile outdoor gas-powered string trimmer designed to meet the demands of both professional landscapers and passionate gardeners. This robust machine combines power, efficiency, and ease of use, making it a top choice for managing grass, weeds, and other vegetation.

One of the standout features of the MTD OGST-3106 is its powerful 31cc 2-cycle engine. This engine is engineered to deliver exceptional performance, allowing users to tackle thick underbrush and heavy grass with ease. The engine is designed for optimal fuel efficiency, reducing the need for frequent refueling during larger jobs. In addition to power, the lightweight design of the trimmer ensures that users can maneuver it effortlessly, reducing fatigue even during prolonged use.

The MTD OGST-3106 incorporates a straight shaft design, which provides extended reach for accessing hard-to-reach areas such as under decks or along fences. This feature enhances its versatility, making it suitable for a variety of applications, from trimming along sidewalks to edging flower beds. Moreover, the unit is equipped with a dual-line cutting head that allows for increased cutting width and efficiency, ensuring a cleaner and faster job.

Another key characteristic of the MTD OGST-3106 is its easy-start technology. The trimmer features user-friendly starting mechanisms that make it simple to get the engine running, even for those who may not have extensive experience with gas-powered equipment. This eliminates some of the common hassles associated with starting similar machines, making it accessible to users of all skill levels.

Durability is a hallmark of the MTD OGST-3106, constructed with high-quality materials that withstand the rigors of outdoor use. Its robust build ensures longevity and reliability over time, even when facing tough environmental conditions. The trimmer also includes ergonomic grips that enhance comfort and control, enabling users to work efficiently while minimizing strain on their hands and wrists.

In conclusion, the MTD OGST-3106 is a powerful and user-friendly gas string trimmer that combines advanced technology with practical features. It is ideal for anyone looking to maintain their outdoor space effectively. Whether you are a professional landscaper or a DIY enthusiast, the MTD OGST-3106 is designed to help you achieve professional-quality results with ease and efficiency. Its blend of power, durability, and ergonomic design sets it apart in the competitive market of outdoor power equipment.
Top Page Image Contents