Simplicity HMSK110, OSHK80, HMSK80 manual 985468

Auger and Impeller Group - 32”

NOTE: Unless noted otherwise, use the standard hardware torque specification chart.

985468

End of hub to be flush with end of rolled down

4

Torque to 30 -34 ft-lbs.

40 - 46 Nm.

shaft (Ref. 9).

2

1

	33
	16	10
14	17
		10
	18	11
		12

		5
10	7	6

9 8

	2
	Torque to
3	18-21 ft-lbs.
	24 - 28 Nm.

19

13

6

15

30	Impeller to be positioned
	against bearing before
32	tightening set screw.

Marked side of worm gear must contact against left thrust washer to assure proper gear mesh.

20

29 26

21	22	15
	18

23

14

25

24

31

15

Torque to 9 - 11 ft-lbs.

12 - 15 Nm.

Auger assembly stamped "R".

Apply grease until

28it appears at ends of auger assembly (2 places).

27

Auger assembly stamped "L".

The above parts group applies to the following Mfg. Nos.:

1693656 1180M, 11HP Manual Start

1693657 1180M, 11HP Manual Start (Export)

1694244 1180E, 11HP Electrical Start

© Copyright 2002 Simplicity Manufacturing, Inc. All Rights Reserved. 48 TP 400-2307-03-LW-S