Simplicity HMSK80, OSHK80, HMSK110 manual Engine & Frame Group 9HP, Electric Start

Engine & Frame Group - 9HP, Electric Start

NOTE: Unless noted otherwise, use the standard hardware torque specification chart.

986098

Position idler pulley (Ref. 34) at	3
center of slot in clutch arm (Ref. 31).

			1		Use 0-2
					washers
					between						59
					Ref. 58 & 31
					to assure a
					centered
					belt and no							Hook one end of spring
					interference
												(Ref. 36) over clutch rod
					between					4	5
												assembly (Ref. 31)
					pulleys Ref.						6
										35		between tabs and other
					27 & 34.		34		57
												end into slot in frame.
						58						8
						57						9	11
					57							7
	2			28					30
				32					36			10
								33
				31
													12
					29
				27
						30						13
							24
												14
			28									15
					25
						23							16
				26
						21		22	21		19		17
									20
			Hook one end of spring (Ref. 24)
			into top hole of idler arm (Ref. 25)
			and other end into top hole of the							18
Long hub of idler pulley			pilot arm assembly in the Traction
(Ref. 27) to be toward			Drive Group.
idler arm (Ref. 25).
Secure engine lead
wire for headlight to				51	50
oil filler tube.			52
		53										37
	54
55
						56
				47	46	45
			48
Torque to
		49
10 - 12 ft. lbs.
14 - 19 Nm.						42					38
			44	43	21
										40
						21		42
Position belt stop (Ref. 42)
					44	43
1/16 to 1/8 inch from belt											39
when auger clutch is										41	Right rear bolt
engaged.

The above parts group applies to the following Mfg. Nos.:

1694243 970E, 9HP Electrical Start

© Copyright 2002 Simplicity Manufacturing, Inc. All Rights Reserved. 34 TP 400-2307-03-LW-S