Auger Housing and Chute Group - 24”
NOTE: Unless noted otherwise, | 983960 |
use the standard hardware torque specification chart.
| Decal must cover |
| gap at hinge pivot. |
5 | 6 |
|
4 |
3 |
7 |
Plastic washer |
| 33 | |
(Ref. 3) goes | 2 | ||
| |||
between chute |
|
| |
and deflector. |
|
| |
1 |
| 1 | |
|
| ||
16 |
| 8 | |
|
| 9 |
12
17 |
32 |
Scraper blade should be on inside of housing.
10
Coat top and bottom of chute ring with grease.
11 |
31 |
30 13
29 | 28 |
27 |
13 |
14 |
15
16 |
21 |
20 |
19 |
17
18 |
26
22
25 | 24 | 23 |
The above parts group applies to the following Mfg. Nos.:
1693650 | 860M, 8HP Manual Start | 1693985 | 860M, 8HP Manual Start (Export) |
1693651 | 860M, 8HP Manual Start (Export) | 1694242 | 860E, 8HP Electric Start |
1693763 | 860M, 8HP Manual Start | 1693652 | 860DLX, 8HP Manual Start |
1693775 | 860M, 8HP Manual Start (Export) | 1693653 | 860DLX, 8HP Manual Start (Export) |
1693984 | 860M, 8HP Manual Start | 1694241 | 860DLXE, 8HP Electric Start |
© Copyright 2002 Simplicity Manufacturing, Inc. All Rights Reserved. | 50 | TP |