Auger and Impeller Group - 24”
NOTE: Unless noted otherwise, |
| 985466 |
use the standard hardware torque |
|
|
specification chart. |
|
|
| End of hub to be flush | |
| with end of rolled down | |
4 | shaft (Ref. 9). | 1 |
|
|
Torque to 30
40 - 46 Nm.
2 |
14 | 16 |
|
17 |
18 |
11 |
10 |
10 |
|
| 5 |
10 | 7 | 6 |
9 | 8 |
2 |
| Torque to | |
3 | ||
24 - 28 Nm. | ||
|
15 |
19 |
6 |
12 |
13 |
Impeller to be positioned against bearing before tightening set screw.
Marked side of worm gear must contact against left thrust washer to assure proper gear mesh.
20 | 21 | 22 |
18 | 23 |
|
14 |
29 | 26 | 25 |
| 24 | |
|
|
Torque to 9 - 11
12- 15 Nm.
27
Auger assembly stamped "R".
Apply grease until
28it appears at ends of auger assembly (2 places).
Auger assembly stamped "L".
The above parts group applies to the following Mfg. Nos.:
1693650 | 860M, 8HP Manual Start | 1693985 | 860M, 8HP Manual Start (Export) |
1693651 | 860M, 8HP Manual Start (Export) | 1694242 | 860E, 8HP Electric Start |
1693763 | 860M, 8HP Manual Start | 1693652 | 860DLX, 8HP Manual Start |
1693775 | 860M, 8HP Manual Start (Export) | 1693653 | 860DLX, 8HP Manual Start (Export) |
1693984 | 860M, 8HP Manual Start | 1694241 | 860DLXE, 8HP Electric Start |
© Copyright 2002 Simplicity Manufacturing, Inc. All Rights Reserved. | 44 | TP |