Simplicity HMSK80, OSHK80, HMSK110 manual 985467

Auger and Impeller Group - 28”

NOTE: Unless noted otherwise,		985467
use the standard hardware torque
specification chart.
	End of hub to be flush
4	with end of rolled down
	shaft (Ref. 9).	1

Torque to 30 -34 ft-lbs.

40 - 46 Nm.

2

14 16

17

18

11

10

10

		5
10	7	6

9 8

2

	Torque to
3	18-21 ft-lbs.
	24 - 28 Nm.

15

19

6

12

13

Impeller to be positioned against bearing before tightening set screw.

Marked side of worm gear must contact against left thrust washer to assure proper gear mesh.

20 21 22

18 23

14

29	26	25
		24

Torque to 9 - 11 ft-lbs.

12 - 15 Nm.

27

Auger assembly stamped "R".

Apply grease until

28it appears at ends of auger assembly (2 places).

Auger assembly stamped "L".

The above parts group applies to the following Mfg. Nos.:

1693654 970M, 9HP Manual Start

1693655 970M, 9HP Manual Start (Export)

1694243 970E, 9HP Electrical Start

© Copyright 2002 Simplicity Manufacturing, Inc. All Rights Reserved. 46 TP 400-2307-03-LW-S