Simplicity 755M manual Traction Drive Group, 984936

Traction Drive Group

NOTE: Unless noted otherwise,	984936
use the standard hardware torque
specification chart.

10	Retainer to be
	loacted inside frame.
9	11
	14	15
12
13
Coat with synthetic
5W-50 motor oil.
	Torque to
	10 - 14 ft-lbs.

1

	17
16		Apply loctite to
	18	screws and torque	3	2
		to 55 - 60 in-lbs		Pack groove
		(2 places).		with grease.
		12		4
				7
		13		6	8

21

13

			28	19				5
				20
Remove all play out of axle by			27	Tighten when all parts are	19			12
								9
moving axle to left, move set				tight against shoulder of hub.
collar (Ref. 27) to the right to				Maximum gap between Ref 19		22		24
take all play out of sprocket				and 22 when assembled .005" - .007".
						23
assembly (Ref. 29) and tighten.								26
Befiore making this adjustment				29		11
be sure tie bar support	(see Frame Group)						10	25
Is installed between frame sides.			39			Retainer to be
			38	Apply anti-seize		loacted inside frame.
						30		Apply locktite and
33	34			to both ends.
		35						torque to 8 - 10 ft. lbs.
28			36
Torque to			37
10 - 14 ft-lbs.
				40
32					41	31

	Bell crank must
Flat side	pivot freely.
toward bearing.

41

With hub (Ref. 32) away from pivot arm assembly (Ref. 35), tighten so that drive disk (Ref. 39) has no play, but is still free rotate.

42

43

Earred end

44

45

46

The above parts group applies to the following Mfg. Nos.:

1693980 555M, 5HP Manual Start

1693981 555M, 5HP Manual Start (Exp.)

1693982 755M, 7HP Manual Start (Exp.)

1693983 755E, 7HP Electric Start

© Copyright 2001 Simplicity Manufacturing, Inc. All Rights Reserved. 14 TP-400-2561-00-IW-S