Heat & Glo LifeStyle BAY-38HV manual For Direct Spark Ignition DSI Wiring, Appliance Requirements

For Direct Spark Ignition (DSI) Wiring

Appliance Requirements

This appliance requires that 110-120 VAC be wired to the factory installed junction box. Maintain correct polarity when wiring the junction box.

Optional Accessories

Optional fan and remote control kits require that 110-120 VAC be wired to the fireplace junction box.

Wall Switch

Position the wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) or less of 16 A.W.G. minimum wire and connect it to the fireplace ON/OFF switch pigtails.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC- TION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPERAND DANGEROUS OPERATION. VERIFY PROPER OPERATION AFTER SERVICING.

							476-500
OPTIONAL REMOTE,						DSI CONTROL VALVE
WALL SWITCH		L2
OR THERMOSTAT		(NEUTRAL)
(ON CERTIFIED UNITS ONLY)
	100-254A			OPTIONAL
	JUNCTION	L1
				FAN				459-591
	BOX	(HOT)
				SWITCHES				IGNITOR
	120 VAC
	BLACK
ON/OFF							WHITE	ORANGE
	120VAC POWERCORD	REM	FAN				BLUE		501-592
									DSI
			GROUND						MODULE
				WHITE		BLUE	WHITE
							YELLOW
		GROUND					GREEN
		TO
		FIREPLACE					BLUE
		CHASSIS		WHITE
				BLACK
FLAME SENSOR/SPARKER
				ON/OFF SWITCH
IGNITION	GAS
MODULE	VALVE
	REMOTE OUTLET
		FAN OUTLET			CONNECTORS
NEUTRAL	GROUND						HOT
Figure 31. Direct Spark Ignition Wiring Diagram
				28