Heat & Glo LifeStyle BAY-38HV manual Installing the Vent System, Identifying Vent Components

		VERTICAL
		TERMINATION
				STORM COLLAR
		HORIZONTAL		ROOF FLASHING
		TERMINATION
				HORIZONTAL PIPE
	Termination Kits			SUPPORT
				PIPE LENGTH
		WALL FIRESTOP
SLK-01D			CEILING	WALL BRACKET
		90 DEGREE	FIRESTOP
	SLK-TVCD
		ELBOW
	SLK-01TRD	PVK-80
Figure 6.	Vent System Components and Termination Kits

Step 3. Installing the Vent System

A. Vent System Approvals

These models are approved to use SL-series direct vent pipe components and terminations (see Figures 5 and 6). Approved vent system components are labeled for identifi- cation. This pipe is tested and listed as an approved com- ponent of the fireplace. The pipe is tested to be run inside an enclosed wall. There is no requirement for inspection openings at each joint within the wall. There is no required pitch for horizontal vent runs. NO OTHER VENTING SYS-

TEMS OR COMPONENTS MAY BE USED.

Detailed installation instructions are included with each vent termination kit and should be used in conjunction with this Installers Guide.

The flame and ember appearance may vary based on the type of fuel burned and the venting configuration used.

Identifying Vent Components

The vent systems installed on this gas fireplace may in- clude one, two, or three 90° elbow assemblies. The rela- tionships of vertical rise to horizontal run in vent configura- tions using 90° elbows MUST BE strictly adhered to. The rise to run relationships are shown in the venting drawings and tables. Refer to the diagrams on the next several pages.

NOTE: Two 45° elbows may be used in place of one 90° elbow. Rise to run ratios in the vent system must be followed if 45° elbows are used.

12

NOTE: If the vertical vent component is 10 feet or more, you may want to install the vertical baffle to improve flame appearance. Vertical baffle kit (BAF-VERT) is located in the manual bag. Center the vertical baffle on the four inch flue and with self tapping screws secure the baffle to the inside of the firebox (see Figure 7).

VERTICAL BAFFLE

KIT (BAF-VERT)

Figure 7.