Heat & Glo LifeStyle BAY-38HV manual Wiring the Fireplace, Standing Pilot Ignition Wiring Diagram

			BLACK S2	REMOTE SWITCH
3/16” PIGGYBACK CONNECTOR
				PIGTAIL
			ON
			OFF
	WHITE T2		ON/OFF
			SWITCH
GAS VALUE	RED T1
		THERMOPILE
THERMOCOUPLE				OPTIONAL WALL SWITCH,
		BLACK S1
Figure 29. Standing Pilot Ignition Wiring Diagram				THERMOSTAT OR REMOTE

Step 8. Wiring the Fireplace

NOTE: Electrical wiring must be installed by a licensed electrician.

CAUTION: DISCONNECT REMOTE CONTROLS IF AB- SENT FOR EXTENDED TIME PERIODS. THIS WILL PRE- VENT ACCIDENTAL FIREPLACE OPERATION.

For Standing Pilot Ignition Wiring

Appliance Requirements

•This appliance DOES NOT require 110-120 VAC to operate.

!WARNING: DO NOT CONNECT 110-120 VAC TO THE GAS CONTROL VALVE OR WALL SWITCH OR THE APPLIANCE WILL MALFUNCTION AND THE VALVE WILL BE DESTROYED.

Optional Accessories

Optional fan and remote control kits require that 110-120 VAC be wired to the factory installed junction box before the fireplace is permanently installed.

Wall Switch

Position the wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) continuous wire or less length of 18 A.W.G. minimum wire and connect it to the fireplace ON/OFF switch pigtails.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC- TION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPERAND DANGEROUS OPERATION. VERIFY PROPER OPERATION AFTER SERVICING.

	VARIABLE SPEED CONTROL	NOTE: IF ANY OF THE ORIGINAL WIRE
		AS SUPPLIED WITH THE APPLIANCE
		MUST BE REPLACED, IT MUST BE
BLK	BLK	REPLACED WITH TYPE 105OC RATED WIRE.
	JUNCTION BOX
BLK	BLK	BLOWER RECEPTACLE
		BLK
BLK
	BLK

WHT WHT

BLK

GROUND

TEMPERATURE

SENSOR SWITCH

BLOWER

GRN

BLKWHT

JUNCTION BOX

110-120 VAC

FAN

Figure 30. Fan Wiring Diagram

TEMPERATURE

SENSOR SWITCH

SPEED CONTROL

(RHEOSTAT)

27