Cub Cadet SWE 528 warranty Practices, Your Responsibility Restrict the use

Page 4

2

Safe

Operation

WARNING: Engine Exhaust, some of its constituents, and certain vehicle compo- nents contain or emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm.

DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death.

TrainingPreparation

Practices

WARNING

This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before at- tempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol.

HEED ITS WARNING!

Your Responsibility Restrict the use

of this power machine to persons who read, understand

and follow the warnings and instructions

in this manual

and on the machine.

1.Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble and operate. Keep this manual in a safe place for future and regular reference and for ordering replacement parts.

2.Be familiar with all controls and their proper operation. Know how to stop the machine and disengage them quickly.

3.Never allow children under 14 years old to operate this machine. Children 14 years old and over should read and understand the operation instructions and safety rules in this manual and should be trained and supervised by a parent.

4.Never allow adults to operate this machine without proper instruction.

5.Thrown objects can cause serious personal injury. Plan your snow-throwing pattern to avoid discharge of material toward roads, bystanders and the like.

6.Keep bystanders, helpers, pets and children at least 75 feet from the machine while it is in operation. Stop machine if anyone enters the area.

7.Exercise caution to avoid slipping or falling, especially when operating in reverse.

1.Thoroughly inspect the area where the equipment is to be used. Remove all doormats, newspapers, sleds, boards, wires and other foreign objects, which could be tripped over or thrown by the auger/impeller.

2.Always wear safety glasses or eye shields during operation and while performing an adjustment or repair to protect your eyes. Thrown objects which ricochet can cause serious injury to the eyes.

3.Do not operate without wearing adequate winter outer garments. Do not wear jewelry, long scarves or other loose clothing, which could become entangled in moving parts. Wear footwear which will improve footing on slippery surfaces.

4.Use a grounded three-wire extension cord and receptacle for all units with electric start engines.

5.Adjust collector housing height to clear gravel or crushed rock surfaces.

6.Disengage all control levers before starting the engine.

7.Never attempt to make any adjustments while engine is running, except where specifically recommended in the operator’s manual.

8.Let engine and machine adjust to outdoor temperature before starting to clear snow.

9.To avoid personal injury or property damage use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Serious personal injury can occur when gasoline is spilled on yourself or your clothes, which can ignite. Wash your skin and change clothes immediately.

a.Use only an approved gasoline container.

b.Extinguish all cigarettes, cigars, pipes and other sources of ignition.

c.Never fuel machine indoors.

d.Never remove gas cap or add fuel while the engine is hot or running.

e.Allow engine to cool at least two minutes before refuel- ing.

f.Never over fill fuel tank. Fill tank to no more than ½ inch below bottom of filler neck to provide space for fuel expansion.

g.Replace gasoline cap and tighten securely.

h.If gasoline is spilled, wipe it off the engine and equip- ment. Move machine to another area. Wait 5 minutes before starting the engine.

i.Never store the machine or fuel container inside where there is an open flame, spark or pilot light (e.g. furnace, water heater, space heater, clothes dryer etc.).

j.Allow machine to cool at least 5 minutes before storing.

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Form no -01791A Two-Stage Snow Thrower Model SWE06/02/2006 Finding and Recording Model Number Table of ContentsCustomer Support Chute clean-out tool is fastened to the top Your Responsibility53% %842! #!54/ %. /0%2!4 %, 352&!#%3Practices Your Responsibility Restrict the useDo not modify engine Your ResponsibilitySetting Up Your Snow Thrower Tighten hand knobs securing upper handle to lower handleShear Pin Storage Chute Clean-Out ToolTire Pressure Operating Your Snow Thrower Know Your Snow ThrowerOperating Your Snow ThrowerGas & Oil Fill-Up Stopping The EngineStarting The Engine Electric StarterTo Engage Augers To Engage DriveAuger Control Test Making Adjustments Shift CableChute Control Drive Control Shift LeverSkid Shoes Auger ControlMaintaining Your Snow Thrower General RecommendationsEngine LubricationShave Plate and Skid Shoes Replacing BeltReplacing Skid Shoe Replacing Shave PlateAuger Belt Roll auger belt off the pulley as shown in FigureFriction Wheel Rubber Drive BeltWheel and friction wheel disc. See Figure Off-Season Storage Preparing EnginePreparing Snow Thrower Short-Term StorageThis section Addresses minor Service issues Trouble- shootingPage Parts List To order replacementOr visit Parts, call the Customer Dealer Referral Line at    738-04194 Flange Shoulder Screw Lock PlateClutch Lock Cam Shoulder Nut, 1/4-2055 56 Friction Wheel Disc Assembly AB Screw, 1/4-20 x790-00096 Auger Cable Guide Bracket 748-0190 Spacer 790-00226 Frame CoverPage U.S.A Canada Contact MTD Products Limited, Kitchener, on N2G 4J1, or callMANUFACTURER’S Limited Warranty for

SWE 528 specifications

The Cub Cadet SWE 528 is a powerful and versatile snow blower designed for homeowners who demand efficiency and reliability during winter months. This model is notable for its robust performance and innovative features that make snow removal an easier and more streamlined task.

One of the standout characteristics of the SWE 528 is its 28-inch clearing width, allowing users to clear large areas of snow in a single pass. The machine is powered by a dependable 420cc OHV engine, delivering ample power and torque to tackle even the most stubborn snow. The engine's design ensures smooth operation, providing the strength needed to clear heavy, wet snow and dealing effortlessly with snowdrifts.

The SWE 528 features a heavy-duty steel auger that efficiently breaks up and gathers snow, sending it through an impressive 200-degree adjustable chute. This pivotal chute design allows for precise control over the direction of snow disbursement, giving users the ability to decide where to send the snow, whether it's onto a driveway, yard, or away from pathways.

Another notable technology in the SWE 528 is its electric start function, which provides a hassle-free way to fire up the engine regardless of the cold weather conditions. This feature is especially beneficial for those who may struggle with traditional pull-start mechanisms in frigid temperatures. Moreover, the model includes a reliable 6-speed transmission that features both forward and reverse settings, allowing for greater mobility and control when navigating various terrains and snow depths.

Comfort is also a key focus in the design of the Cub Cadet SWE 528. It comes equipped with ergonomically designed handles, which provide a comfortable grip and reduce user fatigue during extended use. Additionally, the heated hand grips keep hands warm while operating the snow blower in the coldest conditions, making it an excellent choice for winter storms.

The SWE 528 is built to withstand the elements with its durable construction, featuring a rust-resistant finish and high-impact components that are made to endure harsh winter conditions. Overall, the Cub Cadet SWE 528 combines power, convenience, and durability, making it an excellent investment for anyone looking to simplify their winter snow management tasks. Its impressive features and user-friendly design set it apart in the competitive snow blower market, delivering performance that meets the needs of homeowners in snowy climates.
Top Page Image Contents