Cub Cadet 769-03268 warranty Trouble Shooting, Problem Cause Remedy

Page 21

Problem		Cause		Remedy

Engine fails to start	1.	Choke not in ON position.	1.	Move choke to ON position.
	2.	Spark plug wire disconnected.	2.	Connect wire to spark plug.
	3.	Fuel tank empty or stale fuel.	3.	Fill tank with clean, fresh gasoline.
	4.	Engine not primed.	4.	Prime engine as instructed in
				“Operating Your Snow Thrower”.
	5.	Faulty spark plug.	5.	Clean, adjust gap, or replace.
	5.	Faulty spark plug.
	6.	Blocked fuel line.	6.	Clean fuel line.
	6.	Blocked fuel line.
	7.	Safety key not in ignition on engine.	7.	Insert key fully into the switch.
	7.	Safety key not in ignition on engine.
	8.	Fuel shut-ff valve closed. (If Equipped)	8.	Open fuel shut-off valve.
	8.	Fuel shut-ff valve closed. (If Equipped)

Engine runs erratic	1.	Unit running on CHOKE.	1.	Move choke lever to OFF position.
	2.	Blocked fuel line or stale fuel.	2.	Clean fuel line; fill tank with clean,
				fresh gasoline.
	3.	Water or dirt in fuel system.	3.	Drain fuel tank. Refill with
				fresh fuel.
	4.	Carburetor out of adjustment.	4.	Contact Service Center.

Engine overheats	1.	Carburetor not adjusted properly.	1.	Contact Service Center.

Excessive	1.	Loose parts or damaged auger.	1.	Stop engine immediately and
Vibration				disconnect spark plug wire. Tighten
				all bolts and nuts. If vibration
				continues, have unit serviced by a
				Service Center.

Loss of power	1.	Spark plug wire loose.	1.	Connect and tighten spark plug
				wire.
	2.	Gas cap vent hole plugged.	2.	Remove ice and snow from gas
				cap. Be certain vent hole is clear.
	3.	Exhaust port plugged.	3.	Contact Service Center.

Unit fails	1.	Drive control cable in need of adjust-	1.	Adjust drive control cable. Refer to
to propel itself		ment.		“Adjustments”.
	2.	Drive belt loose or damaged.	2.	Replace drive belt.

Unit fails	1.	Chute assembly clogged.	1.	Stop engine immediately and
to discharge snow				disconnect spark plug wire. Clean
				chute assembly and inside of
				auger housing with clean-out tool
				or a stick.
	2.	Foreign object lodged in auger.	2.	Stop engine immediately and
				disconnect spark plug wire.
				Remove object from auger with
				clean-out tool or a stick.
	3.	Auger control cable in need of adjust-	3.	Refer to “Auger Control Test” .
		ment.
	4.	Auger belt loose or damaged.	4.	Refer to Maintenance section.
	5.	Shear pin(s) sheared.	5.	Replace with new shear pin(s).

8

Trouble-

Shooting

NOTE: This section addresses minor service issues. For further details, contact customer assistance.

21

Image 21

Contents Ottawa Street South, KITCHENER, Ontario N2G 4J1 Two-Stage Snow Thrower769-03268 07/10/07Table of Contents Finding and Recording Model NumberCustomer Support Chute Clean-out Tool Result in personal injury. When you see this symbol, HeedYour Responsibility Restrict the use Your Responsibility Safe Operation PracticesSafe Handling of Gasoline Allow machine to cool at least 5 minutes before storingAverage Useful Life Do not modify engineSetting Up Your Snow Thrower Attaching the Shift Rod Attaching the Chute AssemblyClean-Out Tool Final AdjustmentsDrift Cutters If Equipped Skid Shoes Check the adjustment of the auger control as followsTire Pressure Pneumatic Tires AugerKnow Your Snow Thrower Operating Your Snow ThrowerDrive Control / Auger Control Lock Chute Clean-Out ToolTwo-Way Chute Control Ignition KeyStopping The Engine Recoil StarterStarting The Engine Electric Starter on certain modelsTo Engage Drive Always observe safety rules when performing any maintenanceTo Engage Augers Operating TipsMaking AdjustmentsShift Rod Drive ControlChute Bracket Adjustment Chute AssemblySee Figure Adjust skid shoes as follows Auger ControlLubrication Maintaining Your Snow ThrowerAuger Belt Replacing BeltsWasher. Torque hex screw 250-325 in. lbs Drive BeltSteps in the opposite order and manner of removal Apply Loctite 262 to the threads of the hex screw usedFriction wheel assembly and hold assembly in position Changing Friction Wheel RubberFriction Wheel Wipe equipment with an oiled rag to prevent rust Off-Season StorageProblem Cause Remedy Trouble Shooting10.30.06 WarrantyFor parts and/or accessories refer to customer support on 6919 Parts List Pièces Détachées Adressez-vous au «Service après-vente»La page 2 pour ce qui concerne les pièces et/ou accessoires Asphalt. Set to Torque to 20-30 in./lbsSee chart on next page./ Voir le tableau à la page prochaîne Part Description RÉF Pièce Ground wire to engine Plug into alternator Lead wire under fuel tankGround wire to engine GroundTec Tec. LH 358 ccPart Description RÉF Pièce Part Description RÉF Pièce For parts and/or accessories refer to customer support on Page 06.30.10 GarantieSolution Causes Problème DépannagePas Souffleuse Propre etCarburant le Videz Gaz Place en bougieEn bague la de Changement Frottement de roue caoutchoucFrottement de Roue ’essieu deAdaptateur Vis la enlever pour po 1/2 de clé une Utilisez .aÉloignez Courroies les de RemplacementTarière la de d’entraînement Courroie Boulon l’autre retirezRoues LubrificationVitesse de ment ’engrenageRéglages Tarière la de CommandeGoulotte La de support du AjustementDes l’entraînement de Commande Vitesses de levier du TigeRoues ’utilisation Conseils Général d’ordre RecommandationsAnt Moteur du ArrêtModèles Certains sur électrique DémarreurGoulotte la de direction de Commande ’orientation CommandePhare Patins’obturateur de Commande Souffleuse la de CommandesAmorçeur Départ de VoletTiques Pneuma Bandages pneus des Pression’ajustement Vérifiez Main Réglages DerniersVitesses de levier du tige la de Installation Goulotte la de InstallationBien passe qu’il ce jusqu’à raccord le sur Tapez Cette Remarque Les RemarqueMoyenne utile vie de Durée Responsabilité VotreGaz de émissions les concernant Avis MatérielsResponsabilité Votre ’essence de ManipulationSeulement De Outil Est goulotte la de dégagement de outil UnGoulotte la ed DégagementVente-après service au d’abord adresser vous sans Vente-après ServiceModèle de numéro le trouver Pour Matières des Table07/09/07 Phases deux neige à Souffleuse4J1 N2G Ontario KITCHENER, South, Street Ottawa 03268-769