To ensure adequate lubricant level:
1.Remove filler plug (Figure 5). Lubricant must be at least up to bottom of lubricant filler hole with unit resting on a level surface.
2.Add lubricant if required. Allow oil to drain to level of plug and replace plug.
IMPORTANT: Use only Ariens special gear lubricant
GENERAL LUBRICATION
IMPORTANT: Wipe each fitting clean before and after lubrication.
IMPORTANT: DO NOT allow grease or oil to get on belts.
NOTE: Apply Sten Mix
| Auger Shaft | |
Auger Gearcase | To grease auger shaft, remove shear bolt nuts | |
and shear bolts. Turn auger on shaft while | ||
| ||
| applying grease at zerk fittings. Replace shear | |
Filler Plug | bolts. | |
|
Figure 5
OS1871 |
Grease |
Oil |
OS1843 |
Figure 6 |
GB - 17 |