Ariens 932102 - 520, 932103 - 624, 932310 - 624 manual Operation, Controls and Features

Page 13

3.Ensure Z bend end of clutch cable is connected to hole in tab on right side of clutch bail.

Check Auger Gearcase Oil

Check oil level in auger gearcase (see Maintenance Section).

Fill Engine Crankcase

IMPORTANT: Engines are shipped without oil in crankcase. Refer to Engine Manual for proper type oil and crankcase capacity.

Fill Engine Fuel Tank

Refer to Engine Manual for proper type and capacity.

Check Function of All Controls

Ensure unit runs and performs properly. Refer to Operation Section.

Run in Attachment Belt

1.Start unit in a well-ventilated area according to Starting and Shut-Offin Operation.

2.Engage attachment clutch lever and run attachment for about 15 minutes.

3.Stop unit, wait for all moving parts to stop, and remove spark plug wire.

4.Adjust clutch according to Attachment Clutch/Brake Adjustment in Service and Adjustments.

OPERATION

WARNING: AVOID INJURY. Read and understand Operational and Fuel Safety Rules before proceeding.

CONTROLS AND FEATURES

See Figure 1 for all Controls and Features.

Discharge Chute Deflector

ALWAYS position discharge chute deflector at a safe angle before starting engine.

DO NOT throw snow any higher than necessary.

Push deflector handle forward or down to

Ignition Switch

Key Switch has two positions: 1. "Stop" - Pulled Out

22. Run - Pushed In

NOTE: DO NOT twist key after

1inserting it.

Primer Bulb

Pushing the Primer Bulb in adds fuel for easier engine start (see Starting and Shut Off).

OS1321

Choke Control Knob

throw snow lower. Pull deflector handle up or

to the rear to throw snow higher.

IMPORTANT: If Chute Deflector does not stay in set position, adjust as directed in Service and Adjustments, or repair before operation.

Discharge Chute

Discharge chute rotates 220°.

ALWAYS position discharge chute in safe direction and angle, away from operator and

2

1

OS1300

1.Choke Closed position: Choke Control chokes off air to engine for easier start.

2.Choke Open position: allows for normal operation.

IMPORTANT: Gradually open choke after engine starts.

bystanders, before starting engine.

Chute Crank (932103, 310)

IMPORTANT: If chute does not stay in set position, adjust as directed in Service and Adjustments, or repair before operation.

Rotate the Chute with Discharge Chute Crank Handle.

IMPORTANT: DO NOT force frozen chute controls. Start engine and run for 3-5 minutes to thaw. If still frozen, take to warm place until controls are free.

Scraper Blade

The scraper blade allows the back of the housing to keep better contact with the surface being cleared. It also prevents damage to the housing from normal wear.

IMPORTANT: DO NOT allow Scraper Blade to wear too far or Auger/Impeller housing will become damaged.

GB - 13

Image 13
Contents Sno-Thro Category Walk Behind Snow Thrower Livello di potenza sonora garantito English Français Español Controls and Features932102 Introduction Table of ContentsSafety Safety Sécurité Safety Decals LocationsOperational Safety Rules Assembly Safety RulesCleaning Fuel Safety RulesHazardous Slopes TransportMaintenance and Service Safety Rules AssemblyStorage Safety Rules Accessory and Attachment Safety RulesCheck Attachment Clutch Cable Discharge ChuteOperation Controls and FeaturesFilling Fuel Tank PRE-STARTStarting and SHUT-OFF Traveling Snow RemovalTransport Maintenance Schedule MaintenanceAuger Shaft General LubricationAttachment Drive Belt Replacement Service and AdjustmentsInstall new attachment drive belt Remove old attachment drive beltAttachment Clutch / Brake Adjustment Discharge Chute Shear Bolts For ReplacementStorage TroubleshootingService Parts AccessoriesEngine Tecumseh SpecificationsYear Limited Sno-Thro Warranty DURA-CLEAN Auger Limited Lifetime Warranty
Related manuals
Manual 25 pages 28.84 Kb

932103 - 624, 932102 - 520, 932310 - 624 specifications

Ariens is a well-known brand in the outdoor power equipment industry, particularly recognized for its high-performance snow blowers. Among its notable models, the Ariens 932310 - 624, 932102 - 520, and 932103 - 624 stand out for their robust construction and innovative features designed to tackle harsh winter conditions.

The Ariens 932310 - 624 is engineered for heavy-duty snow removal with a 24-inch clearing width and a powerful 624cc engine. This model features a reliable Ariens Polar Engine that provides efficient power and ensures consistent performance even during the coldest months. The durable housing construction, combined with a heavy-duty steel frame, offers superior durability and stability, making it an ideal choice for homeowners and professionals alike.

The 932102 - 520 model, with its 20-inch clearing width, is designed for those who require a more compact yet powerful option. Equipped with a 520cc engine, it provides ample power for residential snow removal tasks. This model includes Ariens' patented Auto-Turn technology, allowing for easy maneuverability around trees, mailboxes, and sidewalks. The lightweight, compact design enables storage in smaller spaces, making it suitable for urban environments.

On the other hand, the Ariens 932103 - 624 combines the best features of performance and versatility. With a larger 24-inch clearing width and a powerful 624cc engine, this model excels in clearing heavy snowfall. It also includes features like adjustable chute control, allowing users to direct snow where they want it to go with minimal effort. The heavy-duty tires provide excellent traction, necessary for navigating slippery driveways and pathways.

All three models come equipped with essential safety features, including an ignition switch and safety key to prevent accidental starts. Their ergonomic handlebars and controls are designed for comfort, ensuring ease of use regardless of the operator's experience level. Additionally, each model boasts a two-stage snow removal system that efficiently manages heavy snow, ensuring effective clearing with every pass.

In summary, the Ariens 932310 - 624, 932102 - 520, and 932103 - 624 models bring together powerful engines, durable construction, and advanced technology to provide effective snow removal solutions. They cater to different needs and preferences, making them versatile choices for anyone looking to combat snow build-up efficiently during winter.