Ariens 920022 quick start Step One Assemble Handlebar

Page 2

Step One:

Assemble Handlebar

1.Remove the lower and loosen the upper hardware on the handlebar assembly.

2.Loosen the hardware on the shift rod.

3.Put the speed selector lever in the sixth forward position.

4.Rotate the handlebar into operating position.

NOTE: Be careful not to damage cable spring hooks when rotating handlebar upward.

5.Install and tighten the hardware on the handlebar assembly and shift rod.

Image 2

Contents Quick Start Guide Step One Assemble Handlebar Step Two Install Trigger Cable Assembly Step Three Install Discharge Chute Step Four Install Discharge Chute Crank Step Five Install Remote Deflector Cable Step Five Install Remote Deflector Cable Step Six Check Function of Dual Handle Interlock Step Seven Check Track Tension Step Eight Adjust Skid Shoes Step Nine Check Auger Gearcase Oil Step Ten Check Engine Crankcase Oil Step Eleven Fill Engine Fuel Tank Step Twelve Starting Engine Starting Engine / Step a Choke Starting Engine / Step B Rocker Switch Starting Engine / Step C Fuel Shut Off Valve Starting Engine / Step D Key Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Thirteen Stopping the Engine Additional Resources