Ariens 920022 quick start Step Five Install Remote Deflector Cable

Page 6

Step Five: Install Remote

Deflector Cable

1.Pull rubber seal cap away from snap fitting.

2.Install snap fitting into cable bracket’s mounting hole located under the dash.

3.Position rubber seal cap over the top of snap fitting.

4.Move deflector control lever to rear most position.

5.Attach cable eye to pin on bottom of deflector control lever.

NOTE: Hold down chute deflector cap, if needed, for more cable slack.

Image 6

Contents Quick Start Guide Step One Assemble Handlebar Step Two Install Trigger Cable Assembly Step Three Install Discharge Chute Step Four Install Discharge Chute Crank Step Five Install Remote Deflector Cable Step Five Install Remote Deflector Cable Step Six Check Function of Dual Handle Interlock Step Seven Check Track Tension Step Eight Adjust Skid Shoes Step Nine Check Auger Gearcase Oil Step Ten Check Engine Crankcase Oil Step Eleven Fill Engine Fuel Tank Step Twelve Starting Engine Starting Engine / Step a Choke Starting Engine / Step B Rocker Switch Starting Engine / Step C Fuel Shut Off Valve Starting Engine / Step D Key Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Thirteen Stopping the Engine Additional Resources