Ariens 920022 quick start Step Three Install Discharge Chute

Page 4

Step Three:

Install Discharge Chute

1.Grease underside of discharge chute ring (if not already greased).

2.Remove mounting hardware from auger housing

3.Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed above.

NOTE: Leave discharge chute pedestal loose to help install the chute crank.

Image 4

Contents Quick Start Guide Step One Assemble Handlebar Step Two Install Trigger Cable Assembly Step Three Install Discharge Chute Step Four Install Discharge Chute Crank Step Five Install Remote Deflector Cable Step Five Install Remote Deflector Cable Step Six Check Function of Dual Handle Interlock Step Seven Check Track Tension Step Eight Adjust Skid Shoes Step Nine Check Auger Gearcase Oil Step Ten Check Engine Crankcase Oil Step Eleven Fill Engine Fuel Tank Step Twelve Starting Engine Starting Engine / Step a Choke Starting Engine / Step B Rocker Switch Starting Engine / Step C Fuel Shut Off Valve Starting Engine / Step D Key Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Thirteen Stopping the Engine Additional Resources