Ariens 920022 quick start Step Four Install Discharge Chute Crank

Page 5

Step Four: Install

Discharge Chute Crank

1.Remove gear cover from top of chute pedestal.

2.Slide Chute Crank through the nylon bushing in the support bracket under control panel.

NOTE: Be careful not to damage nylon bushing when attaching crank to the control panel.

3.Connect the chute crank to the pinion gear on discharge chute with spring clip pin.

4.Replace gear cover on top of chute pedestal.

5.Orient the chute and pedestal to its most vertical position and tighten pedestal hardware to 14.8-31.0 lbf-ft (20-42 N∙m).

Image 5

Contents Quick Start Guide Step One Assemble Handlebar Step Two Install Trigger Cable Assembly Step Three Install Discharge Chute Step Four Install Discharge Chute Crank Step Five Install Remote Deflector Cable Step Five Install Remote Deflector Cable Step Six Check Function of Dual Handle Interlock Step Seven Check Track Tension Step Eight Adjust Skid Shoes Step Nine Check Auger Gearcase Oil Step Ten Check Engine Crankcase Oil Step Eleven Fill Engine Fuel Tank Step Twelve Starting Engine Starting Engine / Step a Choke Starting Engine / Step B Rocker Switch Starting Engine / Step C Fuel Shut Off Valve Starting Engine / Step D Key Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Thirteen Stopping the Engine Additional Resources