Ariens 24 LE (920014 s/n 100000 & up) quick start Step Four Install Remote Deflector Cable

Page 12

Step Four: Install Remote

Deflector Cable Cont.

6.Secure cable eye to control lever with sleeve bushing and hairpin.

7.Using the wire hook attached to the deflector cable, hook cable to discharge chute crank.

8.Install cable into clip on top of discharge chute pedestal.

9.Make sure deflector cable loops above gear cover between cable clip and cable support bracket.

10.Test controls to be sure deflector works properly.

NOTE: If deflector does not follow full range of travel See Remote Discharge Deflector Control Adjustment in Owners Manual.

Image 12

Contents Quick Start Guide Step One Assemble Handlebars Step One Assemble Handlebars Unfold Lower Handlebar Step One Assemble Handlebars Attach Upper Handlebar Assembly Step One Assemble Handlebars Attach Control Cables Step One Assemble Handlebars Unfold Upper Handlebar Step One Connect Headlight Wire Harness Step One Assemble Handlebar Step Two Install Discharge Chute Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Step Nine Check Engine Crankcase Oil Step Ten Fill Engine Fuel Tank Step Eleven Starting the Engine Starting Engine / Step a Throttle Starting Engine / Step B Fuel Valve Starting Engine / Step C Key Starting Engine / Step D Choke Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine Additional Resources