Ariens 24 LE (920014 s/n 100000 & up) quick start Step One Connect Headlight Wire Harness

Page 7

Step One:

(Connect Headlight Wire Harness)

NOTE: The headlight wire harness comes attached to the upper handlebar assembly.

1.Route the wire harness along the interior of the right side handlebar.

2.Connect to the engine electrical plug.

3.Press cable anchor into mounting hole in the frame near the engine electrical plug.

4.Secure the wire harness to the handlebars using the cable ties attached to the wire harness.

5.Gather excess wire harness length and fasten together with cable tie included in literature pack.

NOTE: This slide applies to

UNATTACHED handlebars ONLY

Image 7

Contents Quick Start Guide Step One Assemble Handlebars Step One Assemble Handlebars Unfold Lower Handlebar Step One Assemble Handlebars Attach Upper Handlebar Assembly Step One Assemble Handlebars Attach Control Cables Step One Assemble Handlebars Unfold Upper Handlebar Step One Connect Headlight Wire Harness Step One Assemble Handlebar Step Two Install Discharge Chute Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Step Nine Check Engine Crankcase Oil Step Ten Fill Engine Fuel Tank Step Eleven Starting the Engine Starting Engine / Step a Throttle Starting Engine / Step B Fuel Valve Starting Engine / Step C Key Starting Engine / Step D Choke Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine Additional Resources