Ariens 24 LE (920014 s/n 100000 & up) Step One Assemble Handlebars Unfold Lower Handlebar

Page 3

Step One: Assemble Handlebars

(Unfold Lower Handlebar)

1.Remove wheel pins from each side of the unit and slide wheels away from frame. Do not remove wheels completely.

IMPORTANT: Be sure to block wheels or secure unit so it does not move during assembly.

2.Rotate lower handlebar out from unit so lower handlebar mounting holes align with mounting holes on the unit frame.

3.Secure lower handlebar to unit using two 3/8 in x 3/4 in. hex head serrated flange grade 5 bolts.

4.Tighten all four bolts to 25-42 lbf-ft (33,9-56,9 N∙m)

5.Slide both wheels back into place and reinstall wheel pins.

NOTE: This slide applies to

UNATTACHED handlebars ONLY

Image 3

Contents Quick Start Guide Step One Assemble Handlebars Step One Assemble Handlebars Unfold Lower Handlebar Step One Assemble Handlebars Attach Upper Handlebar Assembly Step One Assemble Handlebars Attach Control Cables Step One Assemble Handlebars Unfold Upper Handlebar Step One Connect Headlight Wire Harness Step One Assemble Handlebar Step Two Install Discharge Chute Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Step Nine Check Engine Crankcase Oil Step Ten Fill Engine Fuel Tank Step Eleven Starting the Engine Starting Engine / Step a Throttle Starting Engine / Step B Fuel Valve Starting Engine / Step C Key Starting Engine / Step D Choke Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine Additional Resources