Ariens 24 LE (920014 s/n 100000 & up) Step One Assemble Handlebars Unfold Upper Handlebar

Page 6

Step One: Assemble Handlebars

(Unfold Upper Handlebar)

1.Rotate handlebar into operating position.

NOTE: Be careful not to damage cable spring hooks when rotating handlebar upward.

2.Install the remaining handlebar hardware attaching the upper handlebar assembly to the lower handlebar.

3.Tighten all hardware.

4.Remove packaging around shift rod.

5.Rotate shift rod into place and tighten hardware.

6.Connect shift rod to speed selector arm and adjust as specified. See Selector Adjustment in the Owners Manual.

7.Adjust attachment cable as specified. See Attachment Clutch/Brake Adjustment in the Owners Manual.

8.Adjust the traction cable as specified. See Traction Drive Clutch Adjustment in the Owners Manual.

NOTE: This slide applies to

UNATTACHED handlebars ONLY

Image 6

Contents Quick Start Guide Step One Assemble Handlebars Step One Assemble Handlebars Unfold Lower Handlebar Step One Assemble Handlebars Attach Upper Handlebar Assembly Step One Assemble Handlebars Attach Control Cables Step One Assemble Handlebars Unfold Upper Handlebar Step One Connect Headlight Wire Harness Step One Assemble Handlebar Step Two Install Discharge Chute Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Step Nine Check Engine Crankcase Oil Step Ten Fill Engine Fuel Tank Step Eleven Starting the Engine Starting Engine / Step a Throttle Starting Engine / Step B Fuel Valve Starting Engine / Step C Key Starting Engine / Step D Choke Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine Additional Resources