Ariens 24 LE (920014 s/n 100000 & up) quick start Step One Assemble Handlebar

Page 8

Step One:

Assemble Handlebar

1.Remove the lower and loosen the upper hardware on the handlebar assembly.

2.Loosen the hardware on the shift rod.

3.Put the speed selector lever in the sixth forward position.

4.Rotate the handlebar into operating position.

NOTE: Be careful not to damage cable spring hooks when rotating handlebar upward.

5.Install and tighten the hardware on the handlebar assembly and shift rod.

NOTE: This slide applies to ATTACHED handlebars ONLY

Image 8
Contents Quick Start Guide Step One Assemble Handlebars Step One Assemble Handlebars Unfold Lower Handlebar Step One Assemble Handlebars Attach Upper Handlebar Assembly Step One Assemble Handlebars Attach Control Cables Step One Assemble Handlebars Unfold Upper Handlebar Step One Connect Headlight Wire Harness Step One Assemble Handlebar Step Two Install Discharge Chute Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Cable Step Four Install Remote Deflector Cable Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Step Nine Check Engine Crankcase Oil Step Ten Fill Engine Fuel Tank Step Eleven Starting the Engine Starting Engine / Step a Throttle Starting Engine / Step B Fuel Valve Starting Engine / Step C Key Starting Engine / Step D Choke Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine Additional Resources