Rotary Spreaders Assembly Instructions | Cub Cadet 80 LB specification

Rotary Spreaders - Assembly Instructions

Leg
	On/Off Lever
Lower	Handle Grips
Lower
Handle
		Operating Lever
Hopper and Frame	Handle	Rod
Hopper and Frame

1.Remove the spreader components from the carton. You should find all of the parts shown above plus the Hardware Package. The Hardware Package contains:

1 C-Clip

1Calibration Gauge (ODD)

1Calibration Gauge (EVEN)

1Calibration Gauge Chain

1Clevis Pin, 1/4 x 1/2

1Cotter Pin, 3/32 x 1

1Hex Nut, 5/16-18

1Hex Nut, 5/16-18, Nylock

1Lock Washer, 5/16

4Hex Head Machine Screw, 1/4-20 x 2”

4Machine Screw, 1/4-20 x 1-1/2"

4Hex Screw, 1/4-20 x 3/4”

12Nylock Nut, 1/4-20

2.Install the leg to the hopper and frame assembly by fastening with 4 hex head machine screws, 1/4-20 x 2 and 4 locknuts, 1/4-20.

3.Attach the lower handle to the frame (with the “V” section of the closed section of the handle facing down) using 4 hex head screws, 1/4-20 x 3/4, and 4 nylock nuts, 1/4-20. nuts, 1/4-20.

screws, 1/4-20 x 1 1/2 and 4 nylock nuts, 1/4-20.

5.Fasten the on/off lever to the handle's bracket lugs using the clevis pin in the bottom hole of the lever. Insert the clevis pin from left to right, facing the rear of the hopper. Lock with the 3/32 x 1/2 cotter pin.

6.Attach the operating lever rod to the pivot lever assembly at the bottom-rear of the hopper. First screw the 5/16 hex nut on the threaded end of the operating lever rod, add the 5/16 lock washer, then insert the rod through the hole in the pivot lever assembly and install the 5/16 locknut.

7.Attach the operating lever rod to the on/off lever by inserting the bent end of the rod into the top hole of the lever from left to right and install the C-clip.

8.Pull the on/off lever to the off position and move the shutoff plate assembly to the fully closed position by adjusting the 5/16 hex nuts on the bottom of the operating lever rod.

9.Place the handle grips on the handles.

10.Grease the axle bearings and the gear support.

11.Read the Spreader Calibration instructions packed with your spreader and calibrate following the instructions.

4.Attach the upper handle to the lower handle (with the on/off bracket lugs facing up) using 4 machine