Land Pride 322-215M manual Pull-type Hook-up, Clevis Hook-up, Ball Hook-up

Table of Contents

Section 1: Assembly & Set-up

Land Pride

Pull-type Hook-up

!DANGER

Crushing Hazard between tractor and implement. Do not allow anyone to stand between the tractor and implement while backing-up to an implement.

Clevis Hook-up

Refer to Figure 1-7 & Figure 1-8:

1.Back machine up to the Seed Bed Roller until hole in drawbar hitch is aligned with holes in the clevis hitch.

2.Dismount machine properly and insert hitch pin (#3) through hitch clevis holes and drawbar hitch hole. Install hair pin cotter (#4).

!DANGER

Engage parking brake, shut off tractor and remove key before dismounting from the tractor.

!WARNING

The Seed Bed Roller hitch has negative weight.

!WARNING

See Figure 3-5 on page 15. Chock front and back of roller when using support stand to prevent unit from rolling and causing property damage and/or bodily injury.

25799

Clevis Hook-up (Tractor drawbar height under 13")

Figure 1-7

25783

Clevis Hook-up (Tractor drawbar height 13" and higher)

Figure 1-8

3.Without removing wire snap lock pins (#5A & #5B):

•Unhook wire retainers for both pins (#5A & #5B).

•Rotate bottom of support stand (#1) back until hole “A” is in alignment with wire snap lock pin (#5B).

•Push support stand onto both wire snap lock pins and re-hook wire retainers.

Ball Hook-up

Refer to Figure 1-9:

1.Attach customer supplied 2" ball (#8) to the machine pulling the Seed Bed Roller. Tighten nut supplied with the ball to correct torque. 2" Ball with 3/4" shank (P/N 890-975C) can be purchased from Land Pride.

2.Back machine up to the Seed Bed Roller until the 2" ball is in alignment with ball socket in hitch (#2).

25776

Ball Hook-up (Drawbar height 13" and higher)

Figure 1-9

3.Remove retaining pin (#3), pull up on lock latch trigger (#6) and then pull up on release handle (#4).

4.With handle (#4) up, lower hitch (#2) over 2" ball (#8).

5.Make sure hitch (#2) is fully on ball (#8) and then push handle (#4) down until lock latch (#6) is secured in notch (#7).

6.Insert wire retaining pin (#3) in hole “A” and secure pin in place with its wire retainer.

7.Without removing the two front wire snap lock pins (#5A & #5B):

•Unhook wire retainers for both pins (#5A & #5B).

•Rotate bottom of support stand (#1) back until hole “A” is in alignment with wire snap lock pin (#5B).

•Push support stand onto both wire snap lock pins and re-hook wire retainers.

10 Model SBR48, SBR60 & SBR72 Seed Bed Roller 322-215M 2/23/09