Land Pride 322-215M manual Scraper Bar Adjustment, Ball Hitch Swivel Adjustment

Page 13

Land Pride

Section 2: Adjustments

Table of Contents

Scraper Bar Adjustment

Refer to Figure 2-1:

IMPORTANT: Scraper bar must be adjusted with rear roller resting on the ground to ensure roller rings are in their upper most position.

1.Slightly loosen hex nuts (#3) on both ends of the scraper bar (#1). Nuts should be loose enough to allow scraper bar movement but tight enough to hold the scraper bar in place until nuts have been retightened.

IMPORTANT: Tapping with a hammer may be required to move scraper bar (#1). When doing so, be sure to place a block of wood in the area to be tapped. Tap hammer against the wood and not the scraper bar to help protect the finish.

25784

Scraper Adjustment

Figure 2-1

2.Adjust scraper bar (#1) left or right to center scraper teeth (#A) in the roller flutes and up or down until the teeth just clear the bottom of the roller flutes. Some light tapping with a hammer against a properly placed block of wood may be required to move the scraper bar.

3.Tighten 3/8"-16 nuts (#3) to the correct torque. Refer to “Torque Values Chart For Common Bolt Size” on page 21.

Ball Hitch Swivel Adjustment

Refer to Figure 2-2:

IMPORTANT: Hex flange lock nut (#3) should be adjusted tight enough so that the two mating plates (#1 & #2) make contact but loose enough so that the plates can rotate against each other.

A 16" long socket extension and 1 1/8" hex socket will be required to reach the 3/4" hex flange nut (#3).

1.Hold plate (#1) from turning and tighten hex flange nut (#3) until plate (#1) is against plate (#2).

2.Rotate ball hitch about plate (#2) by hand. If ball hitch will not rotate, back nut (#3) off until it will rotate.

Insert Socket Extension

In This Opening

25785

Ball Hitch Swivel Adjustment

Figure 2-2

2/23/09

Model SBR48, SBR60 & SBR72 Seed Bed Roller 322-215M

11

Page 12 Page 14
Image 13
Page 12 Page 14
Contents With Pull Hitch Option Without Pull Hitch OptionTable of Contents Safety at All Times Practice Safe Maintenance Use a Safety ChainTransport Machinery Safely Wear Protective Equipment Tire SafetyAvoid High Pressure Fluids Hazard Keep Riders Off Machinery848-148C Safety LabelsApplication Using This ManualOwner Assistance Further Assistance Land Pride Service Department East North StreetTractor Requirements Three Point Hitch AssemblyThree-Point Hook-up Pull Type Hook-UpRoller Scraper Assembly Pull Type Hitch Assembly OptionalRefer to -5 & Figure Point Hook-UpClevis Hook-up Pull-type Hook-upBall Hook-up Ball Hitch Swivel Adjustment Scraper Bar AdjustmentOperating Check List Operating ChecklistTransporting Operating Instructions Hitch weight when unhookingPoint Type Field Position to Transport PositionStorage Instructions Unhooking the Seed Bed RollerPoint Type Pull TypeGeneral Operating Instructions Lubrication MaintenanceHours Roller Flange BearingsDrag Harrow Additional Seeding EquipmentDisc Harrow Electric Spin SpreaderComplete One Pass Seeding Application Description Three-Point Pull-Type SBR SeriesFeatures Benefits Features and BenefitsAdditional Torque Values Torque Values Chart For Common Bolt SizeIn-tpi · m Ft-lb Mm x pitchTable of Contents Warranty Corporate Office P.O. Box Salina, Kansas 67402-5060 USA
Top Page Image Contents